INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.
Tools needed:
Parts supplied:
Leveling legs (4)
Parts package is located in dryer drum. Check that all parts are included.
Wire stripper
(direct wire installations)
1/4" nut driver (recommended)
Adjustable wrench that opens to 1" (25 mm) or
#2 Phillips screwdriver
Tin snips
(new vent installations)
Vent clamps
Utility knife
Parts needed:
Check local codes. Check existing electrical supply and venting, and read “Electrical Requirements” and “Venting Requirements” before purchasing parts.
Mobile home installations require metal exhaust system hardware, available for purchase from the dealer from whom you purchased your dryer. For further information, please reference the “Assistance or Service” section of the Dryer User Instructions.
If using a power supply cord:
Use a UL listed power supply cord kit marked for use with clothes dryers. The kit should contain:
■■ A UL listed
■■ A UL listed strain relief.
Location Requirements
Tape measure
Level
Pliers
Caulking gun and compound (for installing new exhaust vent)
You will need:
■■ A location allowing for proper exhaust installation. See “Venting Requirements.”
■■ A separate 30 amp circuit.
3