Display codes

MAINTENANCE 19

DISPLAY CODES AND SPECIAL FUNCTIONS

CODES

Err1

Err2

Err3

Err4

Err5

Err6

Err7

Err8

Err9

Er10

Er12

Er13

Unb

EUAr

CAUSES

¬Washer door is not properly shut..

¬Drainage error.. Water is not emptied within 4 minutes..

¬Temperature sensor error..

¬Heater error or laundry overload.. The set temperature is not reached within specified time.. (Appears at the end of a cycle)..

¬Water level not met within 8 minutes..

¬Dehumidification/heating error..

¬Motor overheat error..

¬Water overflow..

¬Error of the dryer temperature sensor..

¬Error of the water level sensor..

¬Error of the dryer water level sensor..

¬Dryer heater error..

¬Laundry is unevenly distributed..

¬Communication error..

SOLUTIONS

_ Shut the door properly

_ Clean the filter and check the drain hose for blockage.. Remove filter in case any water remains in the unit..

_ Please contact the Service Center..

_ Reduce load and start washing again.. _ Please contact the Service Center..

_ Check the tap and the water pressure.. _ Please contact the Service Center..

_ Please contact the Service Center.. _ Please contact the Service Center.. _ Please contact the Service Center.. _ Please contact the Service Center..

_ Check whether clothes are dry or not and whether there is water still in the drum.. If so allow excess humidity to escape from the appliance and try the drying cycle again..

_ Please contact the Service Center..

_ Redistribute laundry to balance the drum.. _ Please contact the Service Center..

1:16

0:01

60°C --°C 0 800 L--1 L--A End

¬Status information: remaining program time is 1 hour and 16 minutes..

¬Status information: remaining program time is 1 minute..

¬Status information: Wash temperature is 60°C..

¬No heat (cold wash)..

¬No spin..

¬Status information: Spin speed 800 rpm..

¬Manually selected code when laundry weight is less than 1kg..

¬Manually selected code when drum is nearly full..

¬Program is finished..

¬Control panel lock function: Press the "Delay" and the "Start/Pause" buttons simultaneously for 3 seconds after starting a program.. It can no longer be changed by operating buttons or knobs.. The washing machine emits an audible signal while the control panel is locked.. To unlock press the "Delay" and "Start/Pause" buttons again for 3 seconds..

¬Power-off memory function: In case of abrupt power failure or the need to cut off the power during a program cycle, the present settings will be saved and the preset operation will resume when the power is on again..

¬To cancel a program or select a new program and options during the wash cycles:

Press the "Start/Pause" button, then switch off the power and the program is automatically cancelled.. Turn the program selector again to choose another program..