Haier HWDC1000TXVE-U user manual Inlet Hose, Drain hose, Connecting to the power supply, 80 100 cm

Page 8

08 Before use

INSTALLATION

Inlet Hose

1.. Connect the nut on the inlet hose to the connector on the water valve..

2.. Apply inlet hose to a water tab with cold, fresh water..

Note: Use the hose-set supplied with the

1.

appliance. Old hose-sets should not be reused.

 

 

Drain hose

 

1.. Use the drain hose bracket to keep the end of the

 

drain hose retained and prevent the outflow of

 

water.. Don't extend the length of the drain hose;

 

if an extended hose is required, please consult a

1.

serviceman..

2..The height of the drainage outlet must be 80-100 cm.. Fix the drain hose to the clip at the back of the washing machine to prevent it from dropping off..

Note: The drain hose should not be submerged in water and should be securely fixed and leak-free.. If the drain hose is placed on the ground or if the pipe is at a height of less than 80cm, the washing machine will continuously drain while being filled (self-siphoning)..

Connecting to the power supply

Before connecting to the power supply, check:

¬The socket is adequate for the maximum power of the Washer Dryer

(For safety, fuses in the power circuit should be rated for no less than 15A)..

¬The voltage should meet the requirement..

¬The power outlet should be capable of accepting the Washer Dryer plug..

¬Connect the machine to an earthed socket outlet..

2.

80 - 100 cm

2.

Image 8
Contents Washer Dryer Using the appliance Maintenance ¬ ConsumptionImportant Safety Information Howthreadedto wire a 13 amp plugtap.. UK OnlyoutletBlue wire must be connected to the terminal marked N Mains cord close to the machineAccessories ComponentsThanks for purchasing a Haier product 3x Blanking plugsDescription PreparationPreparing The machine Hold the plug and not the electric cable when Safety instructionsEnsure you connect the appliance directly to a Installation Adjusting the bottom coverAdjusting the washer dryer Dismantle the Transportation boltsConnecting to the power supply Inlet HoseDrain hose 80 100 cmControl Panel Dry OnlyLast 3 settings with Amber LED’s¬ Power switch ¬ Program knob ¬ Delay button DrawerCompartment 1 Pre-wash detergent ¬ DisplayProgram selection Program ModesConsumption Table Consumption and technical dataTechnical Data Power supply Turn on the tap.. The water must be clean and clearWashing & Drying Water connectionWASHING&DRYING Setting washing temperature Setting spin speedAfter using the appliance WashingLoad Reference Care ChartWash Load Cleaning & care Cleaning the filterDrain pump when the filter is removed After washingCLEANING&CARE Water inlet and inlet filterMoving the machine Long periods of disuseDisplay codes Display Codes and Special FunctionsTrouble shooting TroubleshootingImportant Disposal Instructions