Installation, Adjusting the bottom cover

Before use

INSTALLATION

Adjusting the bottom cover

Before removing the transportation bolts, please fix the bottom cover to the bottom of the washer dryer.. Lay down the machine (fig.. 1..), screw off the feet and adjust the bottom cover with the four holes corresponding the screw holes of the feet.. Then screw the feet back on through the cover and fix it thus securely to the bottom of the machine (fig.. 2..)..

It keeps out the dampness and reduces the noise..

fig.1

fig.2

Dismantle the Transportation bolts

The transportation bolts are designed for clamping anti- vibration components inside of the washer dryer during the transportation process..

1..Remove the back cover..

2..Remove the three bolts on the rear side and take out the synthetic stabilisers from within the machine..

3..Replace the back cover..

4..Fill the holes left by the bolts with blanking plugs..

Note:

1.When you replace the back cover,the convexity must face to outside, and you have to insert the back cover from the two gaps as shown in fig.3.

2.Keep the transportation bolts and synthetic stabilisers in a safe place for later use.

fig.3

Adjusting the washer dryer

There are adjustable feet under the bottom of the washer dryer.. Before use, they should be adjusted so that the machine is level.. This will minimise vibrations and thus noise during use.. It will also reduce wear and tear.. We recommend using a spirit level to level the appliance..