Haier HWDC1200TXVE-U user manual Important Safety Information, Mains cord close to the machine

Page 3

Before use

 

03

Important Safety Information

Do not use a multiple socket extension cord.. A separate earthed socket is required which shall be accessible at all times..

If the mains cord becomes damaged, it must be replaced by the manufacturer, its service agent or similarly qualified person

withELECTRICALa lead of the same typeCONNECTIONand rating to avoid a hazard(UK.. ONLY)

Never remove the plug from the socket by pulling on the cord, always grasp the plug..

The door may get hot during use, do not touch it and keep children away whilst the machine is operating..

NeverWaterminalopen the detergent drawermarkedwhile the machineNis running. ..Hot water and detergent might be ejected.. When installing the product, make sure the mains cord is not trapped or twisted..

WARNINGS:The brown wire must be connected to the terminal

THIS APPLIANCE IS INTENDED FOR DOMESTIC USE ONLY, COMMERCIAL OR ANY OTHER

marked L.

USE MAY INVALIDATE THE WARRANTY AND MIGHT BE DANGEROUS..

NeverYoutouch ormustoperate the makemachine withsurewet hands theor when bareleadfooted..is firmly secured under Do not put the machine on a carpet that can block the ventilation slots on the bottom of the unit..

Do thenot installcordthis machineclampoutdoors or .in a damp place or expose it to rain.. Do not install this product near a heat source or in direct sunlight..

Do not place any object on the machine when it is operating.. This appliance must be earthed..

If you are disposing of an old appliance,disable the door lock to avoid entrapment of children when playing and cut off the

WATER CONNECTION

mains cord close to the machine..

TheTheapplianceproductmust be connected shouldto a 220-240 voltsbe50 cycleconnectedAC supply by means toof a threethepin socket,watersuitably earthedmainand should be protected by a 13 amp fuse in the plug..

Theusingappliance is suppliednewwithhosea standard sets,13 amp 3-pinoldplug fittedhosewith a 13sets-amp fuseshould.. Should the fuse requirenotreplacement,be re it mustusedbe replaced. with a fuse rated at 13 amps and approved to BS1362..

If the mains plug is unsuitable for the socket outlet in your home or is removed for any other reason,then the cut off plug shouldThebe disposedwaterof safely,pressuredo not insert the cut offmustplug into anotmains outletbetolessprevent thethanhazard of electric0.03Mpashock.. Remove. the fuse before disposal..

Connect to the water main using a standard 3/4 inch

There is a danger of electric shock if the cut off plug is inserted into any 13-amp socket outlet..

Howthreadedto wire a 13 amp plugtap.. (UK Only)outlet.

The wires in the mains lead on this appliance are coloured in accordance with the following code:

Green and Yellow - Earth Blue – Neutral Brown – Live

As theIfcoloursyoumayarenot corresponddisposingwith the markingsofidentifyingantheoldterminalsappliance,in your plug proceed as disablefollows.. the The green and yellow wire must be connected to the terminal in the plug which is marked with the

letterdoorE or with thelockearth symbolto avoidor coloured greenentrapmentand yellow..of children when

The blue wire must be connected to the terminal marked N..

playing.

The brown wire must be connected to the terminal marked L..

You must make sure the lead is firmly secured under the cord clamp..

WATER CONNECTION

The product should be connected to the water main using new hose sets, old hose sets should not be re used.. The water pressure must not be less than 0..03MPa..

Connect to the water main using a standard 3/4 inch threaded tap outlet..

Image 3
Contents Washer Dryer ¬ Consumption Using the appliance MaintenanceMains cord close to the machine Important Safety InformationHowthreadedto wire a 13 amp plugtap.. UK Onlyoutlet Blue wire must be connected to the terminal marked N3x Blanking plugs AccessoriesComponents Thanks for purchasing a Haier productPreparation Preparing The machineDescription Safety instructions Ensure you connect the appliance directly to aHold the plug and not the electric cable when Dismantle the Transportation bolts InstallationAdjusting the bottom cover Adjusting the washer dryer80 100 cm Connecting to the power supplyInlet Hose Drain hoseDry OnlyLast 3 settings with Amber LED’s ¬ Power switch ¬ Program knobControl Panel ¬ Display ¬ Delay buttonDrawer Compartment 1 Pre-wash detergentProgram Modes Program selectionConsumption and technical data Technical DataConsumption Table Water connection Power supplyTurn on the tap.. The water must be clean and clear Washing & DryingWASHING&DRYING Washing Setting washing temperatureSetting spin speed After using the applianceCare Chart Wash LoadLoad Reference After washing Cleaning & careCleaning the filter Drain pump when the filter is removedLong periods of disuse CLEANING&CAREWater inlet and inlet filter Moving the machineDisplay Codes and Special Functions Display codesTroubleshooting Trouble shootingImportant Disposal Instructions