Installation and adjustment
Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine.
Install the bottom plate
After | you open the package, please lean | Back |
the washing machine gently down on soft |
| |
items | ( like the towel cloth, blanket, etc. ). |
|
Install | the bottom plate to the bottom of |
|
the machine, then lift the machine up | Front | |
gently. See to the figure: |
| |
|
| Screw |
| Bottom plate | Soft items |
Adjust the Installation position
The largest allowable slope of the shank base of the machine is 2 .The slanting or rough ground will result in unstable running or stoppage of the machine. Please adjust it with following methods:
Attention
.
Even there's no water in the tub, a certain period is required before spin starting.
Do not use the soak program for the woolen textiles. 
Separate the laundries that are not colorfast from 
other laundries in washing.
The pulsator will not rotate unless the water is
filled to"24L"water level.
The soak procedure can work in cooperation with automatic programs like standard,normal, jeans, and fiber . There is intermittent pulsator stirring during soak.
After the machine starts operation, you can only set the program and procedure during washing,soak and can not make setting in other cases.
4 Push the " water level" button, select suitable water level | Water level |
|
After switching on the power and the "standard"or" normal"programs set,washing machine will execute fuzzy 
program automatically to detect the cloth.After defection, it can set the water level automatically. To select other water level, first push the "start/pause" button, then push the "water level" button to
Confirm it's horizontal:
Hang the lead line to check if it is horizontal.
Adjust the adjustable leg:
1 .To twist the adjustable leg, please first lift up the side of the leg slightly, loosen the adjustable nut, and twist the leg.
2 . After adjustment, fasten the nut.
the adjustable nut
Loosen | Fasten | |
the adjustable feet | ||
| ||
High | Low |
set the water level.
5 Push the "reserve" button to select suitable reserve wash program 
After switching on the power, the reserve program is set to off mode automatically. If you need to set the washing procedure to be finished at reserved time, please push the " reserve " button to set the reserve wash program. Refer to reserve button in Page 10 for selection.
Confirm the operation of reserve program
To change the running program or cancel the reserve setting, you need to switch off the power and make new selection.
6 Push the "Start/Pause" button
5 Close the top lid | 6 Finish washing |
As the top lid opened, the washer will automatically | After finishing wash it'll |
given alarm and stop running, exclusively during | alarm automatically |
draining