Service
Fig. 18. Grease o-ring (221) and place on sleeve. Slide sleeve/piston rod assembly into bottom of cylinder. Re- place o-ring (207) if desired.
Note:
Fig. 20. Use screwdriver to push retaining spring up.
| 207 |
221 | 7750A |
Fig. 18
Fig. 20. Torque seal and packing nut (202) down onto throat adjustment spacer (228) to 100 +/--10 in-lb (75 +/--5 in-lb for 246257) (140 +/--10 in-lb for 287814, 287815).
Remove throat adjustment spacer (228) when pump packings begin to leak after much use. Then tighten packing nut down until leakage stops or lessens. This allows approximately 100 gallons of additional opera- tion before a repacking is required.
7674B
Fig. 20 Note: Make sure retaining ring falls into slot.
Fig. 21. Push in pin.
202
Fig. 21 | 7675A |
|
Fig. 19 | 7726A |
|
14 309277