Service
Fig. 18. Reassemble intake valve with new o-ring (227), seat (212) and ball (214). Seat may be flipped over and used on other side. Clean seat thoroughly. Snap intake spring (236) into place inside ball guide (215).
Spring (236), for model 287946, is optional and not included with the pump.
245889, 287946 only
215
236
215
214
212
227
| 215 |
|
| 214 |
|
227 | 227 | |
on top |
227212 244957 only)
Fig. 19 | 7569A |
Fig. 20. Torque seal and packing nut (202) down onto throat adjustment spacer (228) to 100 +/--10 in-lb (75 +/--5 in-lb for 246257) (140+/--10 in--lb for 287814, 287815).
Remove throat adjustment spacer (228) when pump packings begin to leak after much use. Then tighten packing nut down until leakage stops or lessens. This allows approximately 100 gallons of additional opera- tion before a repacking is required.
202
228
7570c
Fig. 18
Fig. 19. Install intake valve on cylinder. If a wrench is used torque as follows:
67 +/--5 ft-lb (model 244197)
80+/--5 ft--lb (models 244201, 244224, 245904)
200+/--10 ft--lb (models 244954, 246257, 245889, 287946, 277068, 248736, 248971)
200+/--15 ft--lb (model 244957, 287814, 287815)
If a wrench is not used, be sure intake valve is bot- tomed out against cylinder.
ti2332a
Fig. 20
309277 9