4.8.3Device Setting and Configuration Device setup requires:
• Entering the IP address for iServer device (for example 192.168.1.200).
• Specifying Socket number (1000 or 2000 depending on iServer settings).
•Defining RS485 Unit # interface address (1 to 199). Enter "0" for RS232 interface or for iServer.
•Entering Reading command. Normally set to SRT to obtain reading from the devices.If you want to change this setting, refer to HTTPget Section 4.5.
•Defining the Alarm setup (High/Low, High value, or Low value).
•Specifying Pause Interval. It determines how many seconds each subsequential alarm notification will be sent.
•Determining Monitor interval. It establishes the interval or time resolution in seconds for which readings will be obtained from the device.
Figure 4.18 iServer Mail Notifier Device Setting
34