Omega Engineering i.BTX-M manual Disassembly Instruction, Opening the Unit

Page 10

2.4 Disassembly Instruction

You may need to open the unit for one of the following reasons:

•To wire relay connector. (Refer to Figure 2.7)

•To connect or replace the battery.

•To change S5 jumper. In the absence of AC power, and if S5 is installed, the LCD Backlight and iServer Board will be on and running on the battery power. Refer to Section 2.7.

Disconnect the power supply before proceeding.

Remove Cover as shown.

COVER

FLASH

CARD

MOUNTING

SCREWS (2)

RELAY

CONNECTOR

FLASH RESET

SWITCH

S5 (WITH LONG PINS)

JTAG

S5

TRAY

KEEP INSULATOR

COVER ON BATTERY

CLIP WHEN BATTERY

IS NOT BEING USED

REMOVE BATTERY CLIP INSULATOR COVER AND STORE WHERE SHOWN WHEN 9V BATTERY IS BEING USED.

Figure 2.4 Opening the Unit

6

Image 10

Contents User’s Guide OMEGAnet On-Line Service Internet e-mail Info@omega.com Servicing North AmericaTable of Contents List of Figures IServer and iLD Big Display on the Ethernet NetworkFeatures Part Introduction Computer with Standard Web Browser Part 2 Hardware DIP SwitchesMounting Parts of the iServer Unit Parts of the iServer Unit Parts of iServer UnitDisassembly Instruction Opening the UnitRunning on Battery Power 2 10Base-T Crossover WiringRelay Wiring Connections Network Communication Interfaces 1 10Base-T RJ-45 PinoutNetwork Protocols Part Network ConfigurationEthernet MAC Address Dhcp IP AddressPort Number Default IP AddressExample C\Telnet 192.168.1.200 Testing the Connection Part OperationsAssigning an IP Address using iCONNECT ICONNECT SoftwareSetting a New IP Address over the Network Access ControlSetup and Operation using the iServer Web IServer HomeRead Sensor Java Runtime Environment 1.4 Setup instructions Read SensorAccessing iServer units using the internet Java Runtime Environment 1.5 5.0 Setup instructionsDiagnostics Adjustable Chart Pressure/TempRetrieving Data from Flash Option10 Access Control Host Name Refer to .4, DNS#2 RTC is set, and recording is in progress Configuration#1 RTC is not set and Flash Card is empty #4 RTC is not set and the Flash Card is not empty11 Configuration Sensor/Device SetupReal Time Clock THi/Lo BHi/Lo BHi/Hi BLo/Hi BLo/LoFlash Recording Terminal Server Remote Access T75.7F P1014.9mbar Sensor ParametersRemote End Char Telnet Setup Httpget ProgramHttpget using Port ResponseApr -s 192.168.1.200 00-03-34-00-00-06-b6 Httpget and ARP to setup Device IP AddressHttpget -r -S 00000000 Where 14 ARP Commands and Responses ARP ProtocolILOG Software 15 iLOG Software Logging DataInstallation Mail Notifier Software17 iServer Mail Notifier Profile Setup Email Connection Mapi AccessDevice Setting and Configuration Device setup requires 18 iServer Mail Notifier Device SettingPower Part 5 SpecificationsTemperature T PackagingRemote Access Tunneling Network InterfaceAppendix a Glossary Appendix B IP Address Class B Appendix C IP NetmaskMask Dotted Notation Mask Binary Mask Bits Class a Class CDec Hex Binary Appendix D Ascii ChartAscii Dec Hex Binary Char No Parity No parityDec Hex Ctrl Key Definition Appendix D Ascii Chart ContinuationAscii Control Codes Dec Hex Ctrl Key Definition Char EquivPart Approvals Information CE Approval Measurement CategoryWARRANTY/DISCLAIMER Shop on line at omega.com