CLASSIFICATION |
|
| No. |
|
| REV. |
Einstufung |
|
|
| C | ||
SUBJECT | EvalBoard PAN4570 | PAGE |
|
|
| |
Thema |
|
| Seite | 10 of 20 |
| |
CUSTOMER’S CODE |
| PANASONIC’S CODE | DATE | 06.11.2006 | ||
EvalPAN4570 |
|
| Datum | |||
8.3. SELECTING THE HARDWARE PLATFORM
The EmberZNet stack uses a EmberTM platform (EmberTM breakout board and RCM module), which is defined in a BOARD_HEADER file. This file is named dev0455.h and located in the folder
….\Ember\EmberZNet2.5.0\hal\micro\xap2b\em250\board\
IMPORTANT: Because the use and settings of GPIOs on the PAN4570 testboard is different another BOARD_HEADER file is required.
After installation of EmberZNet2.5.0 the required change of the BOARD_HEADER file can be done as follows:
Rename the dev0455.h extracted with EmberZNet for example in dev0455_ember.h Copy the PAN4570.h file from the cd to the location where dev0455.h was located Rename the PAN4570.h file to dev0455.h
PAN4570.h enables D11, D14, SW2 and SW6 connected to PAN4570 for the use of the
The two switches and two LEDs are used as follows:
|
|
|
|
|
board | LED | GPIO | EmberTM name | function |
LIGHT | D11 | 3 | HEARTBEAT_LED | heartbeat |
|
|
|
|
|
LIGHT | D14 | 12 | LIGHT | LIGHT |
|
|
|
|
|
LIGHT | SW2 | 15 | BUTTON 1 | LIGHT ON and networking |
|
|
|
|
|
LIGHT | SW6 | 8 | BUTTON 0 | LIGHT OFF and networking |
|
|
|
|
|
SWITCH | SW2 | 15 | BUTTON 1 | LIGHT ON |
|
|
|
|
|
SWITCH | SW6 | 8 | BUTTON 0 | LIGHT OFF |
|
|
|
|
|
|
|
|
| (Table 4) |
For custom applications 5 buttons and 4 LEDs are available on the testboard, the carrierboard/testboard schematics in part 10 show their connections to the GPIOs. Changes regarding the GPIOs should always be done only in the BOARD_HEADER file.
European Technology Center
Panasonic Electronic Devices (EUROPE) GmbH
APPROVED
genehmigt
CHECKED
geprüft
DESIGNED
Erstellt