Upload of Emberznet Sample Applications

CLASSIFICATION			No.		REV.
Einstufung			DS-Eval4570-2400		C
SUBJECT	EvalBoard PAN4570		PAGE
Thema			Seite	9 of 20
CUSTOMER’S CODE		PANASONIC’S CODE	DATE	06.11.2006
EvalPAN4570			Datum	06.11.2006

8.2. UPLOAD OF EMBERZNET SAMPLE APPLICATIONS

Insert the cd coming with this kit into the drive of your pc and navigate to the folder \software\images. Here two image files are provided for the >simple-lighting< application, simple-lighting-light.ebl and simple-lighting-switch.ebl.

After launching the embedded bootloader load the “LIGHT”-image as follows: On the terminal window type in >1<. The response should read:

begin upload CCCCCC…..

In the terminal program select the file transfer function, set the protocol to “Xmodem”, select the simple-lighting-light.ebl as file and start the transfer. After successful upload the response from PAN4570 is

Serial upload complete

After pressing the RESET button on the testboard the output from PAN4570 is

simple light (<)00000000000000 offline Network init status 93

Pressing SW2 results in D14 turned on and the output on the terminal

EVENT: light on

Pressing SW6 results in D14 turned off and the output on the terminal

EVENT: light off

On the other device run the procedure described above using the simple-lighting- switch.ebl instead. After pressing the RESET button on the testboard the output from PAN4570 as switch is:

simple switch (<)00000000000000 offline Network init status 93

For a guide on operating “simple-lighting” see the EmberTM document \Ember\EmberZNet2.5.0\app\sampleApps.html as a part of the installation of EmberZNet on your pc. Please look at the folder \Ember\EmberZNet2.5.0\app\simple-lighting as well. The basic functionality is described in the simple-lighting.h file, while the operation and function of the buttons and LEDs are desribed in main.c. Remark: For the use of buttons and LEDs on the PAN4570 testboard with “simple-lighting” see also table 4 on the next page.

Following the button actions descibed in sampleApps.html (e. g. setting the coordinator, network joining and connecting) you can remotely switch the LIGHT D14 on and off.

If you would like to boot PAN4570 in embedded bootloader mode again, connect GPIO5 (pin 26 of the 34 pin connectors A-B-C-D on the testboard) to ground while the testboard power is switched to OFF. After switching the power ON again wait 2-3 seconds and remove the ground connection to GPIO5. Now you could upload another image file (for example the em250-rangetest.ebl which is on the cd as well), or run the application.

European Technology Center

Panasonic Electronic Devices (EUROPE) GmbH

APPROVED

genehmigt

CHECKED

geprüft

DESIGNED

Erstellt