Setting the SIMPLEX/DUPLEX Operation

2 CHAPTER CONTINUED

DSELECTING RF OUTPUT POWER

The transceiver has 3 output power levels to suit your operating re- quirements. Low out put power settings during short-distance com- munications may reduce the possibility of interference to other stations, and will reduce current consumption.

qWhile pushing and holding [PTT], [MONI], turn [OFF/VOL] to power ON.

wPush [MONI] to toggle between Low1 (1 W ; Pi), Low2 (2 W ; PiPi) and High (4 W ; PiPiPi).

eTurn the power OFF, and then ON again.

DSETTING THE SIMPLEX/DUPLEX OPERATION

The Simplex/Duplex function changes duplex channels to simplex channels.

qWhile pushing and holding [PTT], [MONI], turn [OFF/VOL] to

power ON.

wTurn CH selector knob to select the desired channel. e Push [W/N] to turn the simplex mode ON.

•A beep (Pi) is emitted.

ePush and hold [W/N] to turn the duplex mode ON.

•A long beep (Pii) is emitted.

rTurn the power OFF, and then ON again.

NOTE: Duplex mode is available between CH 1 to CH 8. (see right.)