Icom IC-F21GM instruction manual Example

SET MODE 4

•Confirmation beep is emitted. (See p. 17)

!0Push [PTT] once more, if you want to use Inverse mode. !1Push [MONI] to complete the setting.

•Confirmation beep is emitted. (See p. 17)

!2Turn the power OFF, and then ON again.

[Example]

To assign code ‘261 (normal)’ as CH12;

qWhile pushing and holding [PTT], [MONI], [W/N], turn [OFF/VOL]

to power ON.

wSelect CH 12.

ePush and hold [W/N] until a beep (Pi) is emitted.

rPush [PTT] twice to choose the 100 digit of the code number. t Push [MONI].

•Confirmation beep is emitted. (See p. 17)

yPush [PTT] six times to choose the 10 digit of the code number. u Push [MONI].

•Confirmation beep is emitted. (See p. 17)

iPush [PTT] once to choose the 1 digit of the code number. o Push [MONI].

•Confirmation beep is emitted. (See p. 17)

!0Push [MONI] to complete the setting.

•Confirmation beep is emitted. (See p. 17)

!1Turn the power OFF, and then ON again.

•DTCS code list

023	071	134	223	306	411	503	631	734
025	072	143	226	311	412	506	632	743
026	073	152	243	315	413	516	654	754
031	074	155	244	331	423	532	662
032	114	156	245	343	431	546	664
043	115	162	251	346	432	565	703
047	116	165	261	351	445	606	712
051	125	172	263	364	464	612	723
054	131	174	265	365	465	624	731
065	132	205	271	371	466	627	732

18