Icom IC-40S instruction manual Other Functions, Time-out timer Power saver, Confirmation beeps

OTHER FUNCTIONS 7

■ Time-out timer [ ■ Power saver [

To prevent continuous, extend transmissions, the transceiver has a time-out timer. This timer turns a transmission OFF 1, 2, 3 or 4 min. after it starts. This timer can be cancelled.

Approx. 5 sec. before the time-out time elapses, the trans- ceiver emits a beep tone.

qPush [LOW] for 2 sec. to enter set mode. w Push [LOW] several times until “tt” appears.

e Push [Y] or [Z] to select the time-out time or to turn the function OFF.

-1, 2, 3 and 4 minutes and OFF are available.

rPush [LOW] for 2 sec. to exit set mode.

4 min. time-out timer is selected.

Time-out timer is cancelled.

The power saver function reduces the current drain to con- serve battery power.

qPush [LOW] for 2 sec. to enter set mode.

w Push [LOW] several times until “PS” appears.

e Push [Y] or [Z] to turn the power saver ON or OFF, re- spectively.

r Push [LOW] for 2 sec. to exit set mode.

■Confirmation beeps [

You can select silent operation by turning beep tones OFF or you can have confirmation beeps sound at the push of a switch by turning beep tones ON. The beep tone volume is linked with [VOL].

qPush [LOW] for 2 sec. to enter set mode. w Push [LOW] several times until “bE” appears.

e Push [Y] or [Z] to turn the confirmation beep ON or OFF, respectively.

r Push [LOW] for 2 sec. to exit set mode.

15