Icom IC-40S Battery Packs, Charging Battery pack Precautions, Rapid charging with the BC-119

Page 16

6 BATTERY PACKS

Charging

Battery pack

precautions

charging

DRapid charging with the BC-119

The optional BC-119 provides rapid charging of battery packs.

NEVER attempt to charge dry cell bat- teries. This will cause internal liquid leakage and damage the battery case and transceiver.

The BP-195 or BP-196 BATTERY PACK in- cludes rechargeable Ni-Cd batteries and can be charged approx. 300 times. Charge the battery pack before first op- erating the transceiver or when the bat-

One AD-81 and an AC adapter (may be supplied with the BC-119 depending on version) are additionally required.

Charging periods: 1.5 hours (w/BP-195) 2 hours (w/BP-196)

NEVER connect two or more chargers at the same time.

Charging may not occur under temper- atures of 10°C (50°F) or over tempera- tures of 40°C (104°F).

When using BC-119: If the charge indicator flashes orange, vehicle bat- tery voltage is low and charging is not possible. Check the vehicle bat- tery voltage in this case. If the charge indicator flashes red, there may be a problem with the battery pack (or charger). Re-insert the battery pack or contact your dealer.

tery pack becomes exhausted.

If you want to be able to charge the bat- tery pack more than 300 times, the fol- lowing points should be observed:

1.Avoid overcharging. The charging pe- riod should be less than 48 hours.

2.Use the battery until it becomes al- most completely exhausted under normal conditions. We recommend battery charging just after transmitting becomes impossible.

Turn power

OFF.

BC-119+

AD-81

BC-119+

AD-81

Check orientation for correct charging. (Packed together as the AD-81.)

Check orientation for correct charging. (Packed together as the AD-81.)

12

Image 16
Contents I40S N33 Supplied Accessories Accessories included with the transceiver QtyTable of Contents Accessory Attachment Battery pack replacementAntenna Belt clipPanel Description Panel description1EXTERNAL DC Power Jack Charge Function display Select the desired channel with the Y/Z switches Push LOW to select the output power if necessaryBasic Operation Receiving and transmittingDSetting the backlighting timer Display backlightingLock function Monitor functionRepeater operation Push and hold PTT to transmitScan Operation Scan typesOpen scan Open ScanGroup and priority scans Setting scan tagSelect the priority channel if desired Push LOW for 2 sec. to exit Set mode Scan resume ConditionCalling a waiting station using pocket beep Squelch opens and the signal can be heardTone Squelch Operation Tone squelch operation Pocket beep operationBattery Packs Charging Battery pack PrecautionsRapid charging with the BC-119 Tery pack becomes exhaustedMultiple charging with the BC-121 Regular chargingAbout the battery pack Installing batteries in the battery caseBattery pack life Operating periodOther Functions Time-out timer Power saverConfirmation beeps Turning the microphone remote control function ON/OFF Transmit lockoutOptional HM-75A functions HM-75A functionsTroubleshooting Problem Possible Cause SolutionSpecifications DGeneral DTransmitterDReceiver Current drain approxOptions Battery packsOther options Kamihigashi, Hirano-ku, Osaka 547 Japan