Icom IC-40S instruction manual 1EXTERNAL DC Power Jack Charge

Page 7

y SCAN TYPE SELECTION SWITCH [O/G]

➥Push to select the scan types in order. (p. 8)

•Open scan—“OS” appears.

•Group scan—“GS” appears.

•Priority scan—“PS” appears.

➥When the group or priority scan is selected, this switch sets the displayed channel as the priority channel for the selected scan when pushed for 2 sec. (p. 9)

•While the priority channel is set, the priority channel is dis- played at the right of the operating channel.

u OUTPUT POWER SWITCH [LOW]

➥Push this switch to toggle between high and low output power. (p. 5)

➥Enters set mode when pushed for 2 sec.

➥Scrolls the set mode contents while in the set mode.

iDUPLEX SWITCH [DUP]

➥Toggles the selected channel between duplex or simplex operation on channels 1 to 8. (p. 7)

➥Toggles the lock function ON and OFF when pushed for 2 sec. (p. 6)

• appears” when the lock function is activated.

o FUNCTION DISPLAY (p. 4)

!0TRANSMIT INDICATOR (p. 5)

Lights red while transmitting.

PANEL DESCRIPTION 2

!1EXTERNAL DC POWER JACK [CHARGE]

Connect a 12 to 16 V DC power source using the optional cables, CP-12L or OPC-254L, to charge the attached bat- tery pack; or connect the BC-110V wall charger for charg- ing.

CAUTION: This connection is for charging ONLY. Power to the transceiver must be turned OFF during charging.

!2SPEAKER/MICROPHONE

!3EXTERNAL SPEAKER AND MICROPHONE JACKS [SP/MIC]

Connect an optional speaker-microphone or headset, if de- sired. The internal microphone and speaker will not func- tion when either is connected. (See p. 19 for a list of available options.)

!4ANTENNA CONNECTOR (p. 1)

Connects the supplied antenna.

3

Page 6 Page 8
Image 7
Page 6 Page 8
Contents I40S N33 Accessories included with the transceiver Qty Supplied AccessoriesTable of Contents Belt clip Accessory AttachmentBattery pack replacement AntennaPanel description Panel Description1EXTERNAL DC Power Jack Charge Function display Receiving and transmitting Select the desired channel with the Y/Z switchesPush LOW to select the output power if necessary Basic OperationMonitor function DSetting the backlighting timerDisplay backlighting Lock functionPush and hold PTT to transmit Repeater operationOpen Scan Scan OperationScan types Open scanGroup and priority scans Setting scan tagSelect the priority channel if desired Scan resume Condition Push LOW for 2 sec. to exit Set modeTone squelch operation Pocket beep operation Calling a waiting station using pocket beepSquelch opens and the signal can be heard Tone Squelch OperationTery pack becomes exhausted Battery PacksCharging Battery pack Precautions Rapid charging with the BC-119Regular charging Multiple charging with the BC-121Operating period About the battery packInstalling batteries in the battery case Battery pack lifeOther Functions Time-out timer Power saverConfirmation beeps HM-75A functions Turning the microphone remote control function ON/OFFTransmit lockout Optional HM-75A functionsProblem Possible Cause Solution TroubleshootingCurrent drain approx SpecificationsDGeneral DTransmitter DReceiverOptions Battery packsOther options Kamihigashi, Hirano-ku, Osaka 547 Japan
Top Page Image Contents