Telex ur-700 operating instructions HT-700, Set-Up

Page 10

Figure 4

HT-700

HT-700

Power and Mute Switches: Located on the bottom of the handle.

Microphone Gain: Controls the gain of the audio circuit to prevent under or over modulation.

Set-Up

NOTE: Do not use carbon-zinc batteries. 8.4 volt Ni-Cad batteries may be used but will yield shorter run times.

Unscrew the handle and install a 9 volt alkaline battery. Be sure the battery polarity matches the diagram inside the battery holder.

Screw the handle back on.

Do not turn on at this time.

-9-

Image 10

Contents Telex General Information Posi Phase DiversityAntennas Audio Outputs PowerDisplays AudioUR-700 Receiver Specifications Model HT-700 Transmitter Specifications Model WT-700 Transmitter Specifications Front Panel Rear Panel Receiver Set-up Antenna MountingHT-700 Set-UpMicrophone Jack wired as follows WT-700System Set-Up Your System More Susceptible to OutsideAntenna Placement Bracket Mounting Antenna Placement with Accessory Brackets and Cables Antenna ConnectionInstalling Rack Mounts Assembly of Rack MountDouble Mounting Model CLA-5 1/2 Wave Antenna Accessories and Replacement PartsOrder No AC Power Supplies Wave Replacement Antenna Order No Model AB-2 Combination Antenna BracketModel ALP-450 450-900 MHz Directional Log Periodic Antenna Front Connector Mounting KitOrder No FCC Information Customer Service Information April