Telex ur-700 operating instructions Double Mounting

Page 17

Double Mounting:

Align the mid brackets (Item No. 2) with the holes on the adjacent sides of each unit.

Install the previously removed screws. Insert an additional screw (Item No. 4 provided in the parts pack) into the remaining holes. Tighten all screws securely.

Place the two assemblies side by side with the mid brackets together. (The left bracket should fit above the right so that the countersinks are visible.) Install 4 flat head screws (Item No. 5) Tighten all screws securely.

Place the assembly into the 19 inch rack enclosure and insert four #10-32 x 3/8" Phillips pan head screws (supplied) in each corner of the rack ears and secure to your enclosure.

-16-

Image 17
Contents Telex Antennas Posi Phase DiversityGeneral Information Displays PowerAudio Outputs AudioUR-700 Receiver Specifications Model HT-700 Transmitter Specifications Model WT-700 Transmitter Specifications Front Panel Rear Panel Antenna Mounting Receiver Set-upSet-Up HT-700WT-700 Microphone Jack wired as followsYour System More Susceptible to Outside System Set-UpAntenna Placement Bracket Mounting Antenna Connection Antenna Placement with Accessory Brackets and CablesAssembly of Rack Mount Installing Rack MountsDouble Mounting Order No AC Power Supplies Wave Replacement Antenna Accessories and Replacement PartsModel CLA-5 1/2 Wave Antenna Order No Model AB-2 Combination Antenna BracketOrder No Front Connector Mounting KitModel ALP-450 450-900 MHz Directional Log Periodic Antenna FCC Information Customer Service Information April