Telex ur-700 operating instructions System Set-Up, Your System More Susceptible to Outside

Page 12

Set-Up

NOTE: Do not use carbon-zinc batteries. 8.4 volt Ni-Cad batteries may be used but will yield shorter run times.

Open the battery door and install a 9 volt alkaline battery. Be sure the battery polarity matches the diagram inside the battery holder. Close the battery door.

Insert the microphone plug into the connector. Do not turn on at this time.

System Set-Up

NOTE: When employing two or more wireless systems, the micro- phones should be a minimum of 10-15 feet away from the receivers to prevent “front-end” overload.

Turn on the receiver. Check the RF light. If it is on, this indicates potential interference.

The squelch control on the front of the receiver may be adjusted to increase range or reduce interference. Turn the control counter-clock- wise to increase range. CAUTION! DOING SO WILL MAKE

YOUR SYSTEM MORE SUSCEPTIBLE TO OUTSIDE IN-

TERFERENCE! Turn the control clockwise to reduce interference from noise and out side radio signals. It is best to set the squelch with the transmitter turned off. Turn the control counter-clockwise until you hear noise or interference over your sound system. Then turn it clockwise until the noise is squelched off. This setting will give you your best interference free range. Remember, too much squelch will reduce range.

Turn on the microphone power switch. When the power switch is turned on, the battery light will flash one time if the battery is good. If the light does not flash or stays lit continuously, the battery is weak or dead. If the light comes on during use, the battery is weakening and should be replaced as soon as possible.

-11-

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Telex Posi Phase Diversity General InformationAntennas Power DisplaysAudio Outputs AudioUR-700 Receiver Specifications Model HT-700 Transmitter Specifications Model WT-700 Transmitter Specifications Front Panel Rear Panel Receiver Set-up Antenna MountingHT-700 Set-UpMicrophone Jack wired as follows WT-700System Set-Up Your System More Susceptible to OutsideAntenna Placement Bracket Mounting Antenna Placement with Accessory Brackets and Cables Antenna ConnectionInstalling Rack Mounts Assembly of Rack MountDouble Mounting Accessories and Replacement Parts Order No AC Power Supplies Wave Replacement AntennaModel CLA-5 1/2 Wave Antenna Order No Model AB-2 Combination Antenna BracketFront Connector Mounting Kit Model ALP-450 450-900 MHz Directional Log Periodic AntennaOrder No FCC Information Customer Service Information April
Top Page Image Contents