Telex ur-700 operating instructions Installing Rack Mounts, Assembly of Rack Mount

Page 16

Installing Rack Mounts

The UR-700 is supplied with rack mounts for both double and single mounting in a 19" equipment rack. For single mounting, the long and short rack “ears” are used. For dual mounting, use the short “ears and the mid brackets from two UR-700’s.

Item

No.Description

1 Rack Ear, short

2 Mid Bracket

3 Rack Ear, long

4Screw, #6-32 x 3/8" Phillips, pan head

5Screw, #6-32 x 3/16" Phillips, flat head

6Screw, #10-32 x 3/8" Phillips, pan head

Figure 8

Assembly of Rack Mount

Assembly

To assemble the rack mount to the unit(s) and install it into a 19" rack, proceed as follows:

Remove the front Phillips head screws from each side of each unit. Refer to Figure 1.

Align the rack ear (Item No. 1 or 3) with the holes on the side of the unit. Install the previously removed screws. Insert an additional screw (Item No. 4 provided in the parts pack) into the remaining hole. Repeat this step for the opposite side of the unit. Tighten all screws securely.

-15-

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Telex General Information Posi Phase DiversityAntennas Power DisplaysAudio Outputs AudioUR-700 Receiver Specifications Model HT-700 Transmitter Specifications Model WT-700 Transmitter Specifications Front Panel Rear Panel Receiver Set-up Antenna MountingHT-700 Set-UpMicrophone Jack wired as follows WT-700System Set-Up Your System More Susceptible to OutsideAntenna Placement Bracket Mounting Antenna Placement with Accessory Brackets and Cables Antenna ConnectionInstalling Rack Mounts Assembly of Rack MountDouble Mounting Accessories and Replacement Parts Order No AC Power Supplies Wave Replacement AntennaModel CLA-5 1/2 Wave Antenna Order No Model AB-2 Combination Antenna BracketModel ALP-450 450-900 MHz Directional Log Periodic Antenna Front Connector Mounting KitOrder No FCC Information Customer Service Information April
Top Page Image Contents