Telex ur-700 operating instructions Receiver Set-up, Antenna Mounting

Page 9

Receiver Set-up

Connect the supplied AC power adapter to an AC outlet supplying 105 to 125 volts AC, 60 Hz. The 230 volt export model should connect to an AC outlet supplying 210-240 VAC, 50-60 Hz.

Connect the UR-700 to your equipment:

Insert the appropriate audio connector and cable into the mic or line receptacle on the rear of the UR-700.

Insert the other end of the audio cable into the input of your Mixer/Amplifier.

If utilizing the two 1/4 wave antennas supplied, connect both of them to the back of the receiver at a 90angle as shown in Figure 3. Tighten the connectors securely. (If using other types of antennas, refer to the placement instructions on page 14 of this manual.)

Figure 3

Antenna Mounting

-8-

Image 9

Contents Telex Posi Phase Diversity General InformationAntennas Displays PowerAudio Outputs AudioUR-700 Receiver Specifications Model HT-700 Transmitter Specifications Model WT-700 Transmitter Specifications Front Panel Rear Panel Antenna Mounting Receiver Set-upSet-Up HT-700WT-700 Microphone Jack wired as followsYour System More Susceptible to Outside System Set-UpAntenna Placement Bracket Mounting Antenna Connection Antenna Placement with Accessory Brackets and CablesAssembly of Rack Mount Installing Rack MountsDouble Mounting Order No AC Power Supplies Wave Replacement Antenna Accessories and Replacement PartsModel CLA-5 1/2 Wave Antenna Order No Model AB-2 Combination Antenna BracketFront Connector Mounting Kit Model ALP-450 450-900 MHz Directional Log Periodic AntennaOrder No FCC Information Customer Service Information April