
6.4 ACCESSORY CABLE
Wire Color/Description | Connection Examples |
WHITE - External Speaker (+) | Connect to external 4 Ohm audio speaker |
SHIELD - External Speaker | Connect to external 4 Ohm audio speaker |
RED - PA Speaker (+) | Connect to external 4 Ohm PA speaker |
SHIELD - PA Speaker | Connect to external 4 Ohm PA speaker |
BLUE- NMEA Input (+) | Connect to NMEA (+) output of GPS |
GREEN - NMEA Input | Connect to NMEA |
GRAY- NMEA Output (+) | Connect to NMEA (+) input of GPS |
No connection |
When connecting the external speaker or GPS navigation receiver, strip off about 2.5 cm of the specified wire’s insulation, then splice the ends together using proper waterproofing techniques.
Shield |
|
Red |
|
Blue | NMEA OUT ( ) |
Green | NMEA OUT ( ) |
Gray | NMEA IN ( ) |
Shield |
|
White |
|
PA Speaker
GPS Receiver
External Speaker
•The GPS must have the NMEA Output turned on and set to 4800 Baud in the setup menu. If there is a selection for parity select none.
•For further information on interfacing /setting up your GPS. Please contact the manufacturer of the GPS receiver.
•GX3000E can read
•The NMEA supported sentences are:
Input: GLL, GGA, RMC and GNS (RMC sentence is recommended)
Output: DSC and DSE
(DSC sentences to Standard Horizon Plotter for Position Polling)
GX3000E |
| Page 11 |
|