Safety Instructions for the Installer
WARNING
Turn off the power at the switchboard before beginning the installation.
Fire or electrical shock can result if the power is left on.
Be sure no water leaks in at the trans- ducer or sensor mounting location.
Water leakage can sink the vessel. Also confirm that the transducer and sensor will not loosen by ship's vibration. The installer of the equipment is solely responsible for the proper installation of the equipment. FURUNO will assume no responsibility for any damage associated with improper installation.
Use the specified power cable.
Use of other power cable may result in fire.
CAUTION
Do not install the equipment where air bubbles and noise are present.
Performance will be affected.
The following are guidelines for handling of the transducer cable.
-Do not locate near oils and fuels.
-Locate it in a safe place.
-Do no paint the cable.
The sheath of the cable is made of chloroprene rubber (or polychloride vinyl). For this reason do not paint the cable.
Observe the following compass safe distances to prevent interference to a magnetic compass:
| Standard | Steering | |
| compass | compass | |
|
|
| |
Display | 0.5 m | 0.35 m | |
unit | |||
|
| ||
|
|
|
ii