
Cable connection at transponder
Fabrication of cables TTYCS-4 and TTYCS-1Q
L | 50 |
Shield | Remove paint |
| by 50 mm. |
| Cut vinyl sheath. |
L:Depends on equipment connected. Measure at the transponder.
Expose core and fold back shield onto cable.
Vinyl tape
45
6
Lay in clamp where paint was removed.
Connection
Wiring for WAGO connector
Press downward.
Terminal opener
Wire
Twist
WAGO connector
Procedures
1.Twist the cores.
2.Press the terminal opener downward.
3.Insert the wire to hole.
4.Remove the terminal opener.
5.Pull the wire to confirm that it is secure.
15