Multiquip MT55F manual Nameplate and Decals, To start, switch must be in the on position

Page 24
5
NOTICE
CLEAN THE ELEMENT WITH KEROSENE WHEN DIRTY. AFTER THE CLEANING, LUBRICATE IT MIXED OIL (KEROSENE 2~4: ENGINE OIL 1), SQUEEZE OUT THE OIL, AND REPLACE IT. AND CLEAN IT MORE
OFTEN WHEN OPERATING IN DUSTY CONDITIONS. NP-831 J

NAMEPLATE AND DECALS

14

3800 ~ 4100 RPM

NPA-957 J

2

13

To start, switch must be in the “ON” position

NPA 293

11

12

 

READ OWNER’S SERVICE MANUAL BEFORE OPERATING OR

SERVICING THIS MACHINE.

ALWAYS KEEP UNAUTHORIZED, INEXPERIENCED,

UNTRAINED PEOPLE AWAY FROM THIS MACHINE.

MAKE SURE ALL SAFETY DEVICES ARE OPERATIONAL

BEFORE THIS MACHINE IS STARTED. MAKE SURE ENGINE

IS TURNED OFF AND SPARK PLUG WIRE DISCONNECTED

BEFORE SERVICING THE MACHINE OR COMING IN

CONTACT WITH ANY MOVING PART. IF EQUIPMENT IS

POWERED BY AN ELECTRIC MOTOR DISCONNECT

ELECTRICAL PLUG.

NEVER LEAVE MACHINE UNATTENDED WHEN OPERATING.

ALWAYS STOP ENGINE AND ALLOW ENGINE TO COOL

BEFORE ADDING FUEL OR OIL.

NPA-329 J

3

1

 

GASOLINE ONLYDCL205

 

4

 

 

 

CAUTION

OPERATION

Prior to each operation check

To START engine:

Check all nuts and bolts for tightness.

Open fuel filter valve and close choke lever on carburetor.

Check oil levels in both the engine and the lower unit.

Place starter switch to “ON” and pull start rope.

Keep machine at the upright operating position to check.

When engine starts, open the choke lever and warm up the

1. Lower unit assembly-Check sight glass for proper level.

engine for 4-5 minutes before operation.

2. Engine-Fill to the lower outer rim.

 

To STOP engine:

 

 

 

Move the throttle lever quickly from “ON” to “OFF” position.

NPA-975 J

Then move starter switch to “OFF” and close the fuel filtervalve.

 

 

 

Oil

 

öl

 

I’ huile

 

SAE30

NPA-961 E

7~9 cc

10

When you stop the engine, be sure to close the fuel cock

NPA-399 J

Mikasa

OHV

9

CAUTION

ATTENZIONE

ATENÇAÕ

PRECAUCION

*Read operator’s manual carefully before use.

*Libre le manual attentivement avant utillsation.

*Bitte lesen Sie vor inbetriebnahme der Maschine de Bedienungsanleitung sogfältig durch.

*Prima dell’ uso leggere attentamente il manuale.

*Lee com atenÇão o manual de instruÇões antes de usar.

*Leer detenidamente el mamual de instrucciones antes de usar la maquina.

NPA-769 J

NPA-910 J

8

Mikasa

 

6

 

7

CLEANING ELEMENT:

NPA-963 J

MT-

 

Remove the element from the pre-cleaner

Clean the element with solvent

 

Apply SAE30 motor oil with 7~9 cc, and

55F

 

 

 

squeeze out excess oil before re-installing.

PRIMARY AIRFILTER CHECK DAILY DCL207

NAMEPLATE

PAGE 24 — MT55F RAMMER — OPERATION AND PARTS MANUAL — REV. #5 (01/06/12)

Page 23 Page 25
Image 24
Page 23 Page 25
Contents Model MT55F Proposition 65 Warning MT55F Rammer Operation and Parts Manual REV. #5 01/06/12 Table of Contents MT55F Tamping RammerParts Ordering Procedures Ordering parts has never been easierSafety Information Safety MessagesGeneral Safety Engine Safety Transporting Safety General Information Definition of Tamping RammerSpecifications MT-55F Rammer SpecificationsComponents MT55F RammerBasic Engine Initial ServicingOperation Rammer Gearbox and Spring Cylinder Oil BathMotor Oil Grade 16 MT55F Rammer Operation and Parts Manual REV. #5 01/06/12 Normal Shutdown Maintenance DailyMT55F Rammer Operation and Parts Manual REV. #5 01/06/12 Troubleshooting Engine TroubleshootingRammer Troubleshooting Sample Parts List Explanation of Codes in the Remarks ColumnSuggested Spare Parts MT55F Rammer 3TO 5 Units with RobinTo start, switch must be in the on position Nameplate and DecalsPart Name QTY Remarks Crankcase and Engine Assy Part Name QTY Remarks 28 MT55F Rammer Operation and Parts Manual REV. #5 01/06/12 Stiffener Guide Cylinder Assy Part Name QTY Foot ASSY. Option Part Name QTY Remarks Tank and Handle Assy Throttle Body 36 MT55F Rammer Operation and Parts Manual REV. #5 01/06/12 Fuel Cock ASSY. N18L-02 Robin EH-090D Engine Crankcase Assy Valve Guide Robin EH-090D Engine Crankshaft and Piston Assy Spacer T=0.8 Robin EH-090D Engine Intake and Exhaust Assy PIN Spring Robin EH-090D Engine Governor Assy Governor Lever Robin EH-090D Engine Recoil Starter Assy Blower Housing CP Robin EH-090D Engine Carburetor Assy Throttle Valve Robin EH-090D Engine Electric Device Assy Flywheel CP Robin EH-092D Engine Crankcase Assy Ball BEARING, 60074C3 Robin EH-092D Engine Crankshaft and Piston Assy Crankshaft CP Robin EH-092D Engine Intake and Exhaust Assy Gasket Exhaust Robin EH-092D Engine Carburetor Assy Lever SUB ASSY. Throttle Robin EH-092D Engine AIR Cleaner Assy Part Name Robin EH-092D Engine GOVERNOR, Operation Assy Linkage Bushing Robin EH-092D Engine Blower Housing Assy Label Robin EH-092D Engine Recoil Starter Assy Slide PLATE, B Robin EH-092D Engine Accessories Assy Accessory Tool KIT Terms and Conditions of Sale Parts Freight PolicyMT55F Rammer Operation and Parts Manual REV. #5 01/06/12 HERE’S HOW to GET Help
Top Page Image Contents