FLR Flow Transmitter Installation & Programming Instructions
ENTER - The current total can be manually stored in the monitor's flash memory. Press and hold the ENTER key for 2 seconds. The display will respond with a flashing TOTALSVD and then will return to RUN mode.
RESET TOTAL - To reset the monitor total display, press the MENU and ENTER keys simultaneously until TOTALRST starts to flash. The TOTALRST will stop flashing and the display will return to RUN mode at the conclusion of the reset procedure.
Programming Operation (PROGRAM) Mode
The programming mode allows the user to change the configuration and adjust the calibration of the meter. The FLR Flow Transmitter has two types of configura- tion changes in program mode:
•To view or change selections from a predefined list
•To view or change numeric entries
During programming operation, the following four but- ton functions are provided:
MENU - Enters and exits programming mode.
Change to programming mode by pressing the MENU key once. The mode indicator on the display will change from RUN to PROGRAM.
UP ARROW - Use the UP ARROW key to scroll through the configuration choices in a
RIGHT ARROW - Use the RIGHT ARROW key to scroll through the configuration choices in a
ENTER - Used to enter menus to change configura- tions and to save programming information.
NOTE: If any input value exceeds the meter's capabili- ties the LIMIT indicator will begin to flash indicating an invalid entry. Press ENTER once to return to the entry screen to reenter the value.
Cover Removal/Reinstallation
It is necessary to remove the FLR Transmitter cover to access the programming keys. Use a Phillips screw- driver to remove the 4 screws that hold the cover in place, turning them counterclockwise. When program- ming is completed, reinstall the cover. To properly seat the
®
Figure 8. Cover Screw Tightening Sequence
Page 7