Baja Marine H2X manual Fire, Flooding, Swamping and Capsizing, Collisions and Leaking

Page 21

Section 1 • Safety

Try to approach heading into the wind or into the waves.

Keep the victim on the right (starboard) side so the boat operator has the victim constantly in sight.

When almost alongside, stop the engine in gear to prevent propeller "windmilling."

Getting Back Aboard

Try to reach the victim with a pole, or by throwing a life preserver. Do not swim to rescue the victim, except as a last resort.

Assist the person in boarding the boat. The person should normally be brought in over the stern.

If the person is injured or cannot get into the boat, a rescuer should put on a PFD with a safety line attached to the boat and enter the water to assist the victim.

Handle the victim with care. Spinal injuries may have occurred.

C.Fire

Fire is a serious boating hazard. Boats can burn quickly. Do not remain on board and fight a fire for more than a few minutes. If the fire cannot be extinguished within a few minutes, abandon the boat.

Have fire extinguishers handy. A small fire can be extinguished quickly with the right size and type of fire extinguisher.

Extinguish smoking materials, shut off blowers, stoves, engines and generators.

Throw burning materials overboard, if possible.

If the fire is accessible, empty the contents of fire extinguishers at the base of the flames.

If the fire is in the engine compartment and you have an automatic extinguisher that activates, wait 15 minutes before opening the compartment. Have a portable extinguisher ready in case the fire flares up.

Signal for help.

Grab distress signals and survival gear. Put on PFDs. Prepare to abandon ship.

D.Flooding, Swamping and Capsizing

In the event of flooding, swamping or capsizing:

Try to shut off engines, generators and blowers before leaving the boat.

Have everyone put on Personal Flotation Devices (PFDs).

Account for all who were on board.

If the boat is floating stay with the boat. Hang on, or climb on the boat and signal for help.

Only as a last resort should you attempt to swim to shore - it is further away than it looks and you can tire and drown.

E.Collisions and Leaking

In the event of collisions and leaking:

Slow down or stop to reduce water intake, unless maintaining speed will keep the hole above water.

Switch on bilge pump.

Operate manual bilge pump, if the powered bilge pump can't handle the water flow.

Account for everyone on board and check for injuries.

Have everyone put on PFDs.

Stay with the boat.

Signal for help.

If a leak patch is attempted, it should be done from the outside.

In the event of a collision, you are required to file an accident report. Contact a state enforcement agency or the nearest Coast Guard office. If you are boating outside of U.S. waters, consult the nation you are visiting for accident reporting requirements.

H2X®

R

1.11

Speed changes you. TM.

Image 21
Contents Baja Marine For information call 1-865-971-6270 or fax Welcome This page intentionally left blank Introduction Hull Identification Number HIN HIN NumberAbout Your Express Limited Warranty Iii Ignition Protection Breakers and/or Fuses Speed changes you. TM Safety Labels SafetyLegally Mandated Minimum Required Equipment Fire Extinguishing SystemCarbon Monoxide Carbon Monoxide Monitor Lifesaving Equipment Additional Recommended Equipment for Safe Operation Impaired OperationLoad Capacity Stability Power CapacityMaintain Control WeatherGeneral Considerations Chart Your Course Water Sports SkiingSwimming General Emergency SituationsMedical Emergency Water RescueFire Flooding, Swamping and CapsizingCollisions and Leaking International Requirements Safety HotlinesGrounding Propulsion, Control or Steering FailureWaste Disposal Environmental ConsiderationsExcessive Noise Wake/WashNautical Terms Key to Symbols on Controls & Prints This page intentionally left blank Baja Marine Corp This Page Intentionally Left Blank Docking /Lifting /Trailering Passenger Locations General Boat Arrangement2 Hull Basic Boat Dimensions and Clearances Metric Propulsion SystemPropellers General Deck Layout Power Trim Unit and Gauge Description of Major ControlsGear Shift and Throttle Control Trim Tabs Trailer SwitchEngine Alarm System Ignition Shutdown SwitchImportant Gauges Tachometer and Hour MeterNavigation and Anchor Lights Oil Pressure, Water Temperature, Voltmeter and Fuel GaugesPre-Launch, Launch and Post- Launch Checklist Using Your BoatFueling the Boat Trailer Launching and LoadingPersonal Flotation Devices BoardingStarting the Engine Passenger Instruction and LocationStopping the Engine Shifting to Drive the BoatSteering System Power Steering SystemBilge Bilge & Underwater GearFuel & Oil Spillage Bilge PumpsEngines and Stern Drive Maintenance and ServiceBilge Blowers Vibration and CausesImpact to Stern Drive Propeller Removal and InstallationGear case Fuel System Fuel SystemAnti-Siphon Valve Inboard/Outboard Engine Only Fueling Precautions Before and During Fueling ChecklistStatic Electricity and the Fuel System After Fueling Checklist This page intentionally left blank Electrical Systems Electrical SystemsDirect Current DC BatteriesElectrolytic Corrosion & Zinc Anodes Breakers and/or FusesFuse Panel Marine Electronic Cathodic Anti-corrosion System Mercathode Drive Pump Drive Pump w/ K-Plane Trim Tabs Ignition Switch ATTaCH 4 aWg RED Wire To fUsE PanEl MaIn Switch Panel Wire Information FIGThis Page Intentionally Left Blank Options & Accessories Locations Options & AccessoriesAutomatic Fire Extinguisher System Option Fire Extinguisher PortCanvas Swim Platform w/ Ladder Canvas Care and MaintenanceDepth Finder Optional HornHead Systems Stereo SystemRequirements for Operators Portable Head with Pump-OutExhaust Systems Holding Tank OperationVent Filter Required Inspection, Service Maintenance Summary Guide for Inspection, Service and MaintenanceInterval Interval Summary Guide For Inspection, Service and MaintenanceUseful Service Information Bilge Area Inspection, Service and Maintenance ProtocolBatteryies Winterization Checklist for Boats Stored on LandTopside and Supplies Boat StorageFuel Systems Fitting Out After StorageFuel System MiscellaneousSecurity Considerations Power Steering System MaintenanceQuick Reference Checklist Boarding the Boat GeneralBoat Systems Starting the Engine Returning to Port General Quick Reference Checklist cont’d Departing GeneralQuick Reference Checklist cont’d Securing the BoatIf the Engine Does Not Start After Market Equipment Checklist Maintenance Log Maintenance Log Cont’d Care & Refinishing Paint Cleaning Agents & Other SubstancesStains & Scratches Fiberglass & GelcoatTopside Areas Permanently Moored or Docked BoatsAcrylic Plastic Sheeting Plastic Glass Canvas and Clear VinylInterior Upholstery Fabric Exterior Upholstery FabricThis Page Intentionally Left Blank Index This Page Intentionally Left Blank