Baja Marine H2X Swim Platform w/ Ladder, Depth Finder Optional, Horn, Canvas Care and Maintenance

Page 61

Section 7 • Options & Accessories

!DANGER

Exhaust fumes from engines contain deadly carbon monoxide gas (CO). Boats with canvas or with poor ventilation are most likely to collect fumes.

CO sickness symptoms include headache, nausea and dizziness. Do not mistake these symptoms for sea sickness.

Ventilate boat. See Section 1.3, Carbon Monoxide, for more details.

Bimini Top or sunshade must not be used when the vessel speed exceeds 45 MPH. Damage to boat or bimini may occur.

Removing or installing canvas on the water can be difficult since rough water or wakes can cause you or your passengers to lose their balance while attempting canvas removal or installation.

6.Swim Platform w/ Ladder

Your H2X may have a swim platform installed with a ladder.

With this option, entering the boat from the water is more convenient, but there are safety rules that must be followed.

1.Never sit on the swim platform when boat is moving.

2.Before using or extending the ladder, make sure engine is off and prop is stopped.

3.It may be difficult to extend the ladder while in the water so it important to leave the ladder down if swimmers are in the water.

4.Always make sure ladder is secure before starting engine.

For safety and ease of installation and removal of canvas, use at least two people.

The following canvas options are available for the H2X:

!DANGER

MAKE SURE ENGINE IS OFF AND PROPELLER IS STOPPED BEFORE USING BOARDING LADDER

7.Depth Finder (Optional)

Cockpit Cover

Mooring Cover

Trailering Cover

A.Canvas Care and Maintenance

See Section 9, page 9.2, for instructions on the care and maintenance of your canvas.

The depth finder that may be installed in your boat is a high- performance digital sonar (See Figure 7.3.1). It works only off the bottom signal and operation is completely automatic. There are no sensitivity or noise controls. All this is made possible by the computer built inside.

Depth Finder

(Fig 7.3.1)

DEPTH

0.00

B.Trailering With Canvas

To trailer your boat with the cockpit cover installed, you must install a mooring cover over the cockpit cover with tie down straps tightened.

5.Horn

Since the depth finder is an automatic sonar, all you have to do is turn the power on. It will give you a water depth reading within seconds. Once it finds the bottom, the depth finder locks on to it and automatically adjusts the sensitivity and noise suppression circuits. It will track the bottom at speeds over 70 MPH.

ELECTRIC HORN

The horn is operated by a switch on the dash and is protected by a fuse under the dash. There is no maintenance required on the horn itself, although it is advisable to avoid spraying water directly into the horn.

Do not rely on the depth fider to determine a safe depth for swimming. The depth finder reads from the middle of the boat, not the back or front.

H2X®

7.3

Image 61
Contents Baja Marine For information call 1-865-971-6270 or fax Welcome This page intentionally left blank Introduction Hull Identification Number HIN HIN NumberAbout Your Express Limited Warranty Iii Ignition Protection Breakers and/or Fuses Speed changes you. TM Safety Labels SafetyFire Extinguishing System Legally Mandated Minimum Required EquipmentCarbon Monoxide Carbon Monoxide Monitor Lifesaving Equipment Impaired Operation Additional Recommended Equipment for Safe OperationLoad Capacity Stability Power CapacityWeather Maintain ControlGeneral Considerations Chart Your Course Skiing Water SportsSwimming General Emergency SituationsMedical Emergency Water RescueFlooding, Swamping and Capsizing FireCollisions and Leaking International Requirements Safety HotlinesGrounding Propulsion, Control or Steering FailureWaste Disposal Environmental ConsiderationsExcessive Noise Wake/WashNautical Terms Key to Symbols on Controls & Prints This page intentionally left blank Baja Marine Corp This Page Intentionally Left Blank Docking /Lifting /Trailering Passenger Locations General Boat Arrangement2 Hull Propulsion System Basic Boat Dimensions and Clearances MetricPropellers General Deck Layout Description of Major Controls Power Trim Unit and GaugeGear Shift and Throttle Control Trim Tabs Trailer SwitchEngine Alarm System Ignition Shutdown SwitchImportant Gauges Tachometer and Hour MeterNavigation and Anchor Lights Oil Pressure, Water Temperature, Voltmeter and Fuel GaugesPre-Launch, Launch and Post- Launch Checklist Using Your BoatFueling the Boat Trailer Launching and LoadingPersonal Flotation Devices BoardingStarting the Engine Passenger Instruction and LocationStopping the Engine Shifting to Drive the BoatSteering System Power Steering SystemBilge Bilge & Underwater GearFuel & Oil Spillage Bilge PumpsEngines and Stern Drive Maintenance and ServiceBilge Blowers Vibration and CausesImpact to Stern Drive Propeller Removal and InstallationGear case Fuel System Fuel SystemAnti-Siphon Valve Inboard/Outboard Engine Only Before and During Fueling Checklist Fueling PrecautionsStatic Electricity and the Fuel System After Fueling Checklist This page intentionally left blank Electrical Systems Electrical SystemsDirect Current DC BatteriesBreakers and/or Fuses Electrolytic Corrosion & Zinc AnodesFuse Panel Marine Electronic Cathodic Anti-corrosion System Mercathode Drive Pump Drive Pump w/ K-Plane Trim Tabs Ignition Switch ATTaCH 4 aWg RED Wire To fUsE PanEl MaIn Switch Panel Wire Information FIG This Page Intentionally Left Blank Options & Accessories Locations Options & AccessoriesFire Extinguisher Port Automatic Fire Extinguisher System OptionCanvas Swim Platform w/ Ladder Canvas Care and MaintenanceDepth Finder Optional HornHead Systems Stereo SystemRequirements for Operators Portable Head with Pump-OutHolding Tank Operation Exhaust SystemsVent Filter Summary Guide for Inspection, Service and Maintenance Required Inspection, Service MaintenanceInterval Interval Summary Guide For Inspection, Service and MaintenanceUseful Service Information Bilge Area Inspection, Service and Maintenance ProtocolBatteryies Winterization Checklist for Boats Stored on LandTopside and Supplies Boat StorageFuel Systems Fitting Out After StorageFuel System MiscellaneousSecurity Considerations Power Steering System MaintenanceBoarding the Boat General Quick Reference ChecklistBoat Systems Starting the Engine Returning to Port General Quick Reference Checklist cont’d Departing GeneralSecuring the Boat Quick Reference Checklist cont’dIf the Engine Does Not Start After Market Equipment Checklist Maintenance Log Maintenance Log Cont’d Care & Refinishing Paint Cleaning Agents & Other SubstancesStains & Scratches Fiberglass & GelcoatTopside Areas Permanently Moored or Docked BoatsAcrylic Plastic Sheeting Plastic Glass Canvas and Clear VinylInterior Upholstery Fabric Exterior Upholstery FabricThis Page Intentionally Left Blank Index This Page Intentionally Left Blank