Baja Marine H2X manual Passenger Instruction and Location, Starting the Engine

Page 40
(fig. 3.4.2)

Section 3 • Using Your Boat

If there are passengers not wearing PFDs, the PFDs must be readily accessible. “Readily accessible” means out of the storage bag and unbuckled.

All throwable flotation devices (cushions, rings, etc.) must be right at hand.

6.Passenger Instruction and Location

Everyone on board must be told about the boat’s behavior from starting to getting up on plane.

Before the operator does any high-speed maneuvers or rapidly accelerates or decelerates the boat, passengers must be warned to sit and hold on and must heed the warning.

The operator may have to make rapid changes in speed and/or direction to avoid a problem, with little or no time for alerting passengers. It is critical that all passengers be seated in the designated seating areas and holding on to prevent falling overboard or getting knocked about in the boat at all times when the boat is underway.

7.Starting the Engine

!DANGER

Gasoline vapors can explode

Before starting the engines, open engine compartment and check for gasoline smell.

If you smell gasoline, do not start engine; get everyone off the boat and get trained help to find and fix the problem.

If there is no gasoline smell, perform checks specified by manual, then and only then, close engine compartment and run blower for at least 4 minutes before starting.

The engine operation and maintenance manual furnished with your boat describes pre-start and starting procedures. We urge you to thoroughly read and understand your engine manual.

Listed below are basic pre-start and starting reminders. These are not a substitute for the engine manufacturer’s specific recommendations.

Open the engine compartment and check for the smell of gasoline.

IF YOU SMELL GASOLINE, get everyone off the boat, do not operate any electrical switches or light any matches, lighters, etc. Get trained help to find and fix the problem, before starting the engine or operating any switches on the boat.

If you DO NOT smell gasoline:

1.Check all fluid levels and any other necessary checks as specified in Section 8 and in the engine manual.

2.Check that water level in bilge is minimal. Verify that the bilge pump is operating by turning the bilge pump switch to MANUAL and listening for the pump running and check to see that bilge water is being pumped overboard.

3.Close engine compartment.

4.Check fuel level. Be sure

you have enough fuel for (fig. 3.4.1)

your trip. Remember the “1/3 Rule”: Use no more than 1/3 of your fuel for outbound trip; use 1/3 of the fuel for return trip; keep 1/3 for reserve in case of emergency (FIG 3.4.1).

5.Run bilge blowers for at least 4 minutes before attempting to start engine (FIG 3.4.2).

Unlike your automobile engine which is naturally ventilated even when it is not moving, your boat engine compartment (the bilge) does not have sufficient natural ventilation when the boat is not moving or moving

slowly. That is why the engine compartment must have forced ventilation, using the bilge blower, to remove potentially explosive gasoline vapors before the engine is started and when the boat is moving slowly.

Because it may be difficult to remember to turn on the bilge blower every time you slow down the boat,

3.4

H2X®

Image 40
Contents Baja Marine For information call 1-865-971-6270 or fax Welcome This page intentionally left blank Introduction HIN Number Hull Identification Number HINAbout Your Express Limited Warranty Iii Ignition Protection Breakers and/or Fuses Speed changes you. TM Safety Safety LabelsFire Extinguishing System Legally Mandated Minimum Required EquipmentCarbon Monoxide Carbon Monoxide Monitor Lifesaving Equipment Impaired Operation Additional Recommended Equipment for Safe OperationLoad Capacity Power Capacity StabilityWeather Maintain ControlGeneral Considerations Chart Your Course Skiing Water SportsSwimming Emergency Situations GeneralMedical Emergency Water RescueFlooding, Swamping and Capsizing FireCollisions and Leaking Safety Hotlines International RequirementsGrounding Propulsion, Control or Steering FailureEnvironmental Considerations Waste DisposalExcessive Noise Wake/WashNautical Terms Key to Symbols on Controls & Prints This page intentionally left blank Baja Marine Corp This Page Intentionally Left Blank General Boat Arrangement Docking /Lifting /Trailering Passenger Locations2 Hull Propulsion System Basic Boat Dimensions and Clearances MetricPropellers General Deck Layout Description of Major Controls Power Trim Unit and GaugeGear Shift and Throttle Control Trailer Switch Trim TabsIgnition Shutdown Switch Engine Alarm SystemImportant Gauges Tachometer and Hour MeterOil Pressure, Water Temperature, Voltmeter and Fuel Gauges Navigation and Anchor LightsUsing Your Boat Pre-Launch, Launch and Post- Launch ChecklistTrailer Launching and Loading Fueling the BoatBoarding Personal Flotation DevicesPassenger Instruction and Location Starting the EngineShifting to Drive the Boat Stopping the EnginePower Steering System Steering SystemBilge & Underwater Gear BilgeFuel & Oil Spillage Bilge PumpsMaintenance and Service Engines and Stern DriveBilge Blowers Vibration and CausesPropeller Removal and Installation Impact to Stern DriveGear case Fuel System Fuel SystemAnti-Siphon Valve Inboard/Outboard Engine Only Before and During Fueling Checklist Fueling PrecautionsStatic Electricity and the Fuel System After Fueling Checklist This page intentionally left blank Electrical Systems Electrical SystemsDirect Current DC BatteriesBreakers and/or Fuses Electrolytic Corrosion & Zinc AnodesFuse Panel Marine Electronic Cathodic Anti-corrosion System Mercathode Drive Pump Drive Pump w/ K-Plane Trim Tabs Ignition Switch Switch Panel Wire Information FIG ATTaCH 4 aWg RED Wire To fUsE PanEl MaInThis Page Intentionally Left Blank Options & Accessories Options & Accessories LocationsFire Extinguisher Port Automatic Fire Extinguisher System OptionCanvas Canvas Care and Maintenance Swim Platform w/ LadderDepth Finder Optional HornStereo System Head SystemsRequirements for Operators Portable Head with Pump-OutHolding Tank Operation Exhaust SystemsVent Filter Summary Guide for Inspection, Service and Maintenance Required Inspection, Service MaintenanceInterval Summary Guide For Inspection, Service and Maintenance IntervalUseful Service Information Inspection, Service and Maintenance Protocol Bilge AreaWinterization Checklist for Boats Stored on Land BatteryiesTopside and Supplies Boat StorageFitting Out After Storage Fuel SystemsFuel System MiscellaneousPower Steering System Maintenance Security ConsiderationsBoarding the Boat General Quick Reference ChecklistBoat Systems Starting the Engine Quick Reference Checklist cont’d Departing General Returning to Port GeneralSecuring the Boat Quick Reference Checklist cont’dIf the Engine Does Not Start After Market Equipment Checklist Maintenance Log Maintenance Log Cont’d Paint Cleaning Agents & Other Substances Care & RefinishingStains & Scratches Fiberglass & GelcoatPermanently Moored or Docked Boats Topside AreasAcrylic Plastic Sheeting Plastic Glass Canvas and Clear VinylExterior Upholstery Fabric Interior Upholstery FabricThis Page Intentionally Left Blank Index This Page Intentionally Left Blank