Baja Marine 33 manual Fitting Out After Storage, Fuel Systems, Miscellaneous

Page 72

Section 8 • Required Inspection, Service, &

Maintenance

•Keep under a trickle charge.

•When placing battery back into service, remove excess grease from terminals, recharge as necessary and reinstall in boat.

D.Fuel Systems

Gasoline:

•Fill fuel tank with gasoline and the recommended amount of stabilizer and conditioner such as “Stabil®”.

•Run engine(s) for ten minutes to ensure that all gasoline in the carburetor and fuel lines are treated.

Diesel:

•Fill fuel tank with diesel and recommended amount of biocide, “Biobor®”, which prevents bacteria and fungi from contaminating diesel fuel that contains some water.

•Diesel fuel should also get a petroleum distillate additive, such as “Stabil®” or Racor® RX100”. This will absorb water in the fuel and prevent freezing problems.

•Run engine(s) for ten minutes to ensure that all diesel fuel in injectors and fuel lines is treated.

DETAILED WINTERIZING, OPERATING INSTRUCTIONSAND WARRANTY INFORMATION ARE PROVIDED BY THE EQUIPMENT MANUFACTURER AND CAN BE FOUND IN THE OWNER’S PACKET.

!CAUTION

Do not overfill. Filling a tank until the fuel flows from vents is dangerous. Allow room for expansion.

5.Fitting Out After Storage

A.Fuel System

Check the entire fuel system for loose connections, worn hoses, leaks, etc. and repair. This is a primary safety precaution.

Check fuel lines for damage and make sure that they do not come in contact with any moving parts.

B.Battery(ies)

Before installing the batteries, clean the terminal posts with a wire brush or steel wool and then attach the cables. After the cable clamps are tightened, smear the post and clamps with vaseline or grease to exclude air and acid. Do not apply grease before attaching and tightening the terminal clamps. Examine all wiring.

C.Miscellaneous

•Check all thru-hull fittings for unobstructed water passage. Be alert for any deteriorated hoses and/or fittings below the water line which might fail in service and allow water.

•Test the navigation lights.

•Check all wiring for loose connections.

•Check all switches and equipment for proper operation.

•Check bilge blowers for proper operation. Turn on blowers and place hand over hull blower vent to make sure air is coming from vent.

•Anchor lines and gear should be inspected and replaced if necessary.

•Make sure the hull drain plug is in place and tight.

•Clean bilge thoroughly if it was not done at lay-up.

•Check all engine fluid levels.

8.6

33 Outlaw®

Page 71 Page 73
Image 72
Page 71 Page 73
Contents Baja Marine OutlawFor information call 1-865-971-6270 or fax Welcome Everyone that operates the boat should read this manualThis page intentionally left blank Introduction You must learn to operate this boat as well asRead, understand and use this manual Service, Parts and Repair for Your Boat Hull Identification Number HINManufacturer’s Certification About Your Express Limited Warranty Iii Ignition Protection Breakers and/or Fuses Speed changes you. TM Safety Safety LabelsSafe boating means Legally Mandated Minimum Required Equipment Fire Extinguishing SystemCarbon Monoxide Carbon Monoxide Monitor Lifesaving Equipment Additional Recommended Equipment for Safe Operation Impaired OperationPower Capacity Load CapacityPropellers United StatesObserve the safety rules listed below StabilityMaintain Control Chart Your Course WeatherGeneral Considerations Water Sports SwimmingSkiing Emergency Situations GeneralMedical Emergency Water RescueFire Flooding, Swamping and CapsizingSafety Hotlines Collisions and LeakingGrounding Propulsion, Control or Steering FailureInternational Requirements Environmental ConsiderationsFuel and Oil Spillage Waste Disposal Wake/WashExcessive Noise Nautical Terms Key to Symbols on Controls & Prints Baja Marine Corp Optional Only w/ fire portThis Page Intentionally Left Blank General Boat Arrangement Docking /Lifting /Trailering Passenger LocationsCleats Cleats must not be used for lifting 2 Hull Basic Boat Dimensions and Clearances Metric Propulsion SystemGeneral Deck Layout General Deck Layout FIGPower Trim Unit and Gauge Description of Major ControlsGear Shift and Throttle Control Trailer Switch Trim TabsIgnition Shutdown Switch Engine Alarm SystemImportant Gauges Tachometer and Hour MeterOil Pressure, Water Temperature, Voltmeter and Fuel Gauges Navigation and Anchor LightsUsing Your Boat Pre-Launch, Launch and Post- Launch ChecklistTrailer Launching and Loading Fueling the BoatBoarding Personal Flotation DevicesPassenger Instruction and Location Starting the EngineShifting to Drive the Boat Stopping the EngineSteering Systems Hydraulic SteeringPower Steering Power Steering SystemThis page intentionally left blank Bilge & Underwater Gear BilgeFuel & Oil Spillage Drain PlugMaintenance Maintenance and ServiceEngines and Stern Drive Bilge BlowersPropeller Removal and Installation Impact to Stern DriveGear case Fuel System Fuel SystemAnti-Siphon Valve Inboard/Outboard Engine Only Fueling Precautions Before and During Fueling ChecklistStatic Electricity and the Fuel System After Fueling Checklist This page intentionally left blank Battery Maintenance Electrical SystemsElectrical Systems Electrolytic Corrosion & Zinc Anodes Breakers and/or FusesFuse Panel Marine Electronic Cathodic Anti-corrosion System Mercathode Ignition Switch Drive Pump with K-Plane Trim Tabs FIG Switch Panel Wire Information FIG Fuse Panel Wire Diagram FIG This Page Intentionally Left Blank Options & Accessories Options & Accessories LocationsAutomatic Fire Extinguisher System Option Fire Extinguisher PortCanvas Canvas Care and Maintenance Swim Platform w/ Ladder OptionalDepth Finder Optional HornStereo System Standard performance systemOptional performance system Head SystemsExhaust Systems Corsa Performance Quick & Quiet II optionPortable Head with Pump-Out This page intentionally left blank Required Inspection, Service Maintenance Summary Guide for Inspection, Service and MaintenanceInterval Summary Guide For Inspection, Service and Maintenance IntervalUseful Service Information Inspection, Service and Maintenance Protocol Bilge AreaWinterization Checklist for Boats Stored on Land BatteryiesTopside and Supplies Boat StorageFitting Out After Storage Fuel SystemsFuel System MiscellaneousPower Steering System Maintenance Security ConsiderationsQuick Reference Checklist Boarding the Boat GeneralBoat Systems Starting the Engine Quick Reference Checklist cont’d Departing General Returning to Port GeneralQuick Reference Checklist cont’d Securing the BoatIf the Engine Does Not Start After Market Equipment Checklist Equipment Proper Operating ConditionMaintenance Log Maintenance Log Cont’d Paint Cleaning Agents & Other Substances Care & RefinishingStains & Scratches Fiberglass & GelcoatPermanently Moored or Docked Boats Topside AreasAcrylic Plastic Sheeting Plastic Glass Canvas and Clear VinylExterior Upholstery Fabric Interior Upholstery FabricThis Page Intentionally Left Blank Index Index Outlaw

33 specifications

The Baja Marine 33 is a striking testament to the legacy of performance and design in the world of powerboats. Known for its impressive speed and agility, this vessel embodies the perfect blend of luxury and functionality, making it a favorite among boating enthusiasts.

One of the standout features of the Baja Marine 33 is its sleek, aerodynamic design, which plays a crucial role in enhancing its performance on the water. With a length of 33 feet, this boat is built for stability and precision, allowing for smooth navigation even in challenging conditions. The deep-V hull design is engineered to cut through waves effortlessly, providing a thrilling and comfortable ride.

Under the helm, the Baja Marine 33 is typically powered by robust engines that deliver exceptional horsepower. Many configurations include twin engines that can produce a total output exceeding 600 horsepower, allowing for exhilarating speeds and quick acceleration. This powertrain setup is complemented by advanced marine technologies, such as precise steering systems and responsive throttle controls, which make handling the boat intuitive and enjoyable.

The interior of the Baja Marine 33 is designed with comfort and luxury in mind. Spacious cabins provide ample seating for guests, with high-quality upholstery and elegant finishes that enhance the aesthetic appeal of the boat. Additionally, the layout often includes a well-equipped galley, allowing for convenient meal preparation during extended trips.

Safety has always been a priority in Baja's engineering, and the Baja Marine 33 is no exception. It features a range of safety systems, including high-quality navigation lights, a robust bilge pump system, and well-placed handrails to ensure that passengers can move about comfortably and securely.

Versatility is another hallmark of the Baja Marine 33. Whether it’s for day cruising, water sports, or just relaxing with friends and family, this boat can accommodate a range of activities. The ample deck space provides room for sunbathing, while strategically placed storage compartments keep the essentials organized and easily accessible.

In summary, the Baja Marine 33 is a powerful blend of performance, style, and comfort. With its cutting-edge technology, spacious interior, and superior handling, it continues to be a preferred choice for both seasoned mariners and newcomers to the boating world. Whether you’re racing across the waves or enjoying a leisurely day on the water, the Baja Marine 33 promises an unforgettable experience.
Top Page Image Contents