III.SERVICE INFORMATION
1. ERROR CODES
Lamp | No. | Error | Problem | Operation | Control panel | |
display | ||||||
|
|
|
|
| ||
|
|
|
|
|
| |
|
|
| Flow rate stayed below 0.13 | Production stops after |
| |
Error | E11 | Low water | gal/min (0.5 L/min) for 10 sec | water valve turns off | Error no. | |
|
|
| with water valve on | two times |
| |
|
|
| Flow rate stayed above 0.13 | Production stops after |
| |
Error | E14 | Water shutoff | gal/min (0.5 L/min) for 10 sec | water valve turns on | Error no. | |
|
|
| with water valve off | two times |
| |
Error | E53 | Contactor supply | Current stayed below 0.5A for 2 | Production stops after | Error no. | |
sec | contactor switches | |||||
|
|
|
| three times |
| |
Error | E61 | Flow switching | Switching did not complete | Production stops | Error no. | |
valve | within 30 sec | |||||
|
|
|
|
|
| |
|
|
| Open circuit | Production continues | Alternate between | |
— | E74 | Thermistor | as 41°F (5°C) (open | normal display | ||
short circuit [140°F (60°C)] | circuit) or 86°F (30°C) | |||||
|
|
| and error no. | |||
|
|
|
| (short circuit) |
| |
|
| Float switch (if | Upper switch on, lower switch | Production continues | Alternate between | |
— | E82 | provided with | normal display | |||
|
| tank) | off | (for at least 3 min) | and error no. | |
|
|
|
| |||
Add salt |
|
| Salt water pump stayed at 700 |
|
| |
— | Salt water level | spm (strokes per minute) for 90 | Production stops | (Add salt lamp on) | ||
water | ||||||
|
| sec |
|
| ||
|
|
|
|
| ||
— | EE1 | Model setting | Model setting connector lost or | Production stops | Error no. | |
|
|
| wrong |
|
| |
Error | EF0 | Control board | EEPROM error | Production stops | Error no. |
2. SERVICE DIAGNOSIS
Lamp | Error code | Problem | Check | Possible cause | Remedy |
Add salt | — | Salt water pump stayed | Salt water tank | Low salt water | Add salt in salt |
water |
| 700 spm (strokes per |
| concentration | water tank |
|
| minute) for 90 sec | Salt water hose | Loose connection to | Reconnect |
|
|
|
| salt water tank |
|
|
|
|
| Clogged | Unclog |
|
|
|
| Vapor lock | Prime |
|
|
| Filter | Dirty | Clean |
|
|
| Switching | Defective | Repair or replace |
|
|
| regulator | DC supply line open | Correct |
|
|
| (electrolytic cell) | circuit |
|
|
|
| Magnetic switch | Defective | Repair or replace |
|
|
|
| Bad contacts | Repair |
|
|
| Relay | Defective | Repair or replace |
|
|
|
| Bad contacts | Repair |
|
|
| Current sensor | Defective | Repair or replace |
27