Furuno Comprehensive Guide to Assembling and Mounting the Hull Unit for the CH-37

Page 13

Assembling and mounting of hull unit

The hull unit is shipped disassembled as the parts shown in the hull unit kit on pages 1-10 and 1-11. Assemble the hull unit as shown in the procedure below.

Necessary tools

Name	Specification	Remarks

Wrench	For M10 (Hex. size 17 mm)

Wrench	For M20 (Hex. size 20 mm)

Pipe Wrench	55 mm

Ball Wrench	Hex size 4 mm	Supplied with hull unit kit

1.Unscrew 10 pieces of socket head cap screws with the ball wrench (supplied) to detach the soundome.

		Rotate 3 or 4 turns
		by hand to make
		sure that turning
		mechanisms are
		mechanisms are
		functioning properly.
	Kinoruster: Anti-crevice		Apply Kinoruster.
	corrosion sealant (supplied)		Apply Kinoruster.
	corrosion sealant (supplied)
			SOUNDOME

Socket head cap screw (10 pcs, M5 x 30) Spring washer

O-ring

Remove

Protective sponge

Figure 1-3 Detaching the soundome

1-3

Image 13

Contents Color Sector Scanning Sonar 00080821301 Safety Instructions Working with the Sonar OIL Precautions Table of Contents Standard Supply Equipment ListsName Type Code No Remarks Optional EquipmentSystem Configuration Standard Option Hull unit assembly combinationThis page is intentionally left blank Hull Unit Installation position considerationsGeneral mounting considerations Tank length Mounting methodMounting of transducer tank Necessary tools Assembling and mounting of hull unitFilling the soundome with sonar oil How to fasten main shaft to soundome assembly Passing main shaft through the main body flange 11 Fastening the hull unit to the transducer tank 12 Installing the raise/lower drive block 13 Tightening the grease cotton retainer Checking manual raise/lower of transducer with hand crankHull unit installation materials Super Sonar OIL 4L Name Outline Descriptions ’TY Remarks Reinforcement Mounting considerations Transceiver UnitGrounding the Display Unit and Transceiver Unit Display UnitMotion Sensor MS-100 Option Mounting procedureExternal Interface Option 19 Display unit, rear view Bind cables with the cable tie supplied Logarithm Amplifier Video SounderPage Clinometer BS-704 Option 21 Installation Position of ClinometerPage Wiring Among Units WiringCabling diagram Page Connections for synchronizing Tx with other E/S, sonar Synchronizing Transmission with Echo Sounder or Other SonarPress the Menu key Select Sonar at the top of the menu Menu settingThis page is intentionally left blank General Checks AdjustmentsSignal offset adjustment Adjustment of Transceiver UnitSelecting audio frequency Horizontal beamwidth Heading AlignmentMain shaft Adjustment of Motion Sensor, ClinometerMeasuring ship’s semi-permanent inclination angle Soundome PaintingDisplay unit LED StatusLEDs in the display unit con’t Transceiver unit LEDs in the transceiver unit Transceiver unitLEDs in the transceiver unit con’t LEDs in the hull unit Hull unitSystem Menu Changing SpecificationsSystem setting menu description Page Page Page Page 000-803-168-00 Jan Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page カラーセクタースキャニングソナー