Furuno CH-37 manual Display unit, rear view

Page 26

External E/S interface installation kit

Part

Type, Q'ty

Code No.

Q'ty

 

 

 

 

External E/S Interface Assy.

-

-

1

 

 

 

 

XH Connector Assy.

06-312 (6-6P)

006-550-830

1

 

 

 

 

Screw

M3x6

000-881-103

4

 

 

 

 

Screw

M3x8

000-881-404

1

 

 

 

 

Cable Ties

No.249

000-515-871

1

 

 

 

 

1.Remove the display unit cover.

2.Remove the dummy plate at the rear of the display unit.

Remove this dummy plate and fasten External Inter- face module here.

Figure 1-19 Display unit, rear view

3.Connect XH connector assy. to the Interface Module.

4.Fasten the Interface Module to the display unit with M3 x 6 screws and one M3 x 8 screw.

For connecting External Monitor Interface (OP06-14) and External E/S inter- face (OP06-13), remove ESIF Board from OP06-13, and fix ESIF Board on OP06-14.

For connecting logarithm amplifier video sounder, refer to next page.

5.Connect between J2 on the ESIF Board (06P0237) and J3 on the MAIN Board; connect between J1 on the RGB-BUFF Board (03P9229) and J4 on the MAIN Board.

1-16

Image 26
Contents Color Sector Scanning Sonar 00080821301 Safety Instructions Working with the Sonar OIL Precautions Table of Contents Equipment Lists Standard SupplyOptional Equipment Name Type Code No RemarksSystem Configuration Hull unit assembly combination Standard OptionThis page is intentionally left blank General mounting considerations Installation position considerationsHull Unit Mounting of transducer tank Mounting methodTank length Assembling and mounting of hull unit Necessary toolsFilling the soundome with sonar oil How to fasten main shaft to soundome assembly Passing main shaft through the main body flange 11 Fastening the hull unit to the transducer tank 12 Installing the raise/lower drive block Checking manual raise/lower of transducer with hand crank 13 Tightening the grease cotton retainerHull unit installation materials Super Sonar OIL 4L Name Outline Descriptions ’TY Remarks Reinforcement Transceiver Unit Mounting considerationsDisplay Unit Grounding the Display Unit and Transceiver UnitExternal Interface Option Mounting procedureMotion Sensor MS-100 Option 19 Display unit, rear view Logarithm Amplifier Video Sounder Bind cables with the cable tie suppliedPage 21 Installation Position of Clinometer Clinometer BS-704 OptionPage Wiring Wiring Among UnitsCabling diagram Page Synchronizing Transmission with Echo Sounder or Other Sonar Connections for synchronizing Tx with other E/S, sonarMenu setting Press the Menu key Select Sonar at the top of the menuThis page is intentionally left blank Adjustments General ChecksSelecting audio frequency Adjustment of Transceiver UnitSignal offset adjustment Heading Alignment Horizontal beamwidthAdjustment of Motion Sensor, Clinometer Main shaftSoundome Painting Measuring ship’s semi-permanent inclination angleLED Status Display unitLEDs in the display unit con’t Transceiver unit Transceiver unit LEDs in the transceiver unitLEDs in the transceiver unit con’t Hull unit LEDs in the hull unitChanging Specifications System MenuSystem setting menu description Page Page Page Page 000-803-168-00 Jan Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page カラーセクタースキャニングソナー