Furuno CH-37 manual Logarithm Amplifier Video Sounder, Bind cables with the cable tie supplied

Page 27

6. Bind cables with the cable tie (supplied).

		Pass cables from RBG-BUFF
		Board (03P9229) through clamp.
		Bind cables
		with cable tie.
	J4	Fix External Interface module
	J4	with M4 x 8 screws.
		with M4 x 8 screws.
		External
		Interface module
FRONT		REAR

J3

MAIN Board 06P0227

Figure 1-20 Display unit, cover removed, right side view

7.Close the cover.

1.7Logarithm Amplifier Video Sounder

For connecting external video souder (logarithm amplifier:FCV-291,292,1000), modify ESIF board of OP06-13 (as below) and the INTERFACE UNIT VI-1100A. For INTERFACE UNIT VI-1100A modification, refer to installation manual of INTERFACE UNIT VI-1100A.

Modification of E/S interface

1.Remove chip resistor R14 from ESIF board (06P0237).

2.Solder vinyl wire between TP2 and TP4.

R14 TP2

TP4

06P0237

Remove R14

J1 TP0	R14 TP2
TP4
TP3	Vinyl wire
TP1
06P0237

1-17

Image 27

Contents Color Sector Scanning Sonar 00080821301 Safety Instructions Working with the Sonar OIL Precautions Table of Contents Standard Supply Equipment ListsName Type Code No Remarks Optional EquipmentSystem Configuration Standard Option Hull unit assembly combinationThis page is intentionally left blank Installation position considerations Hull UnitGeneral mounting considerations Mounting method Tank lengthMounting of transducer tank Necessary tools Assembling and mounting of hull unitFilling the soundome with sonar oil How to fasten main shaft to soundome assembly Passing main shaft through the main body flange 11 Fastening the hull unit to the transducer tank 12 Installing the raise/lower drive block 13 Tightening the grease cotton retainer Checking manual raise/lower of transducer with hand crankHull unit installation materials Super Sonar OIL 4L Name Outline Descriptions ’TY Remarks Reinforcement Mounting considerations Transceiver Unit Grounding the Display Unit and Transceiver Unit Display UnitMounting procedure Motion Sensor MS-100 OptionExternal Interface Option 19 Display unit, rear view Bind cables with the cable tie supplied Logarithm Amplifier Video SounderPage Clinometer BS-704 Option 21 Installation Position of ClinometerPage Wiring Among Units WiringCabling diagram Page Connections for synchronizing Tx with other E/S, sonar Synchronizing Transmission with Echo Sounder or Other SonarPress the Menu key Select Sonar at the top of the menu Menu settingThis page is intentionally left blank General Checks AdjustmentsAdjustment of Transceiver Unit Signal offset adjustmentSelecting audio frequency Horizontal beamwidth Heading AlignmentMain shaft Adjustment of Motion Sensor, ClinometerMeasuring ship’s semi-permanent inclination angle Soundome PaintingDisplay unit LED StatusLEDs in the display unit con’t Transceiver unit LEDs in the transceiver unit Transceiver unitLEDs in the transceiver unit con’t LEDs in the hull unit Hull unitSystem Menu Changing SpecificationsSystem setting menu description Page Page Page Page 000-803-168-00 Jan Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page カラーセクタースキャニングソナー