6.Center and level the top of the downdraft vent left to right and front to back. Use a ⁹⁄₁₆" wrench to lock the feet into position with the locknuts.
7.Secure the hood vent box to the countertop or cabinet sides with the undercounter mounting brackets attached earlier at the desired location. If mounting to a countertop, use screws or mounting method recommended for the specific type of countertop.
8.Install the top frame support, using the 12 - 3.9 x 9 mm
9.Install the top frame.
B
A
C
D
E
A.12
B.Top frame
C.Guide pins in top frame
D.Hole for top frame guide pins
E.Top frame support
Install Downdraft Vent In-Line (External
Type) Blower Motor
Prepare for Mounting the In-Line Blower System
The
NOTE: The mounting hole locations must span the studs. Additional stud framing may be required. Plywood may be used to span open areas between ceiling or floor joists or roof rafters to aid installation. This structure must be strong enough to support the weight of the
[22.7 kg] min).
Prepare the In-line Blower System
WARNING
Excessive Weight Hazard
Use two or more people to move and install
Failure to do so can result in back or other injury.
1.Using 2 or more people, move the
2.Remove the 10 screws from the front cover of the
3.Remove the front cover of the
NOTE: To make the blower motor housing easier to mount, the blower motor assembly can be removed. If you do not want to remove the blower motor assembly, proceed to “Install
4.Disconnect the motor electrical plug from the blower motor assembly.
5.Remove the screws that secure the blower motor assembly to the
6.Pull the spring clip to release the blower motor assembly. Remove the blower motor assembly from the housing and place it on a covered surface.
A
B C
D
A. Front cover | C. Spring clip |
B. Blower mounting screws | D. Motor electrical plug |
10