Jenn-Air LIB0057678 Complete Installation, Grounding Instructions, Do not use an extension cord

Complete Installation

1.Plug the optional remote up/down switch into the front panel of the vent box.

A

B

A. Remote up/down switch connector

B. Remote up/down switch

2.Use cable tie mounting bases and cable ties to route the switch wiring to an easily accessible area near the front inside of the cabinet.

3.Use 2 screws to secure the remote up/down switch housing to the cabinet.

4.Connect vent system to blower. Vent system must end with a wall or roof cap. Use clamps or duct tape to seal all joints.

Grounding Instructions

This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This appliance is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded.

WARNING: Improper grounding can result in risk of electric shock.

Consult a qualified electrician if the grounding instructions are not completely understood, or if doubt exists as to whether the appliance is properly grounded.

Do not use an extension cord. If the power supply cord is too short, have a qualified electrician install an outlet near the appliance.

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

NOTE: The grounded 3 prong outlet shall be located below the cooktop surface and cannot be placed in a closed cabinet without any access. Route the power cord beneath the downdraft vent system and away from the heat generated by the cooktop of other appliances.

1.Plug 3-prong power cord into a grounded 3-prong outlet located inside the cabinet where the downdraft vent is mounted.

2.Use the remote control or the remote up/down switch to raise the vent hood. (See the “Remote Control Operation” section.) If the vent hood does not rise, check that the circuit breaker has not tripped or a household fuse blown.

3.Remove packing material.

4.Install filters. See “Filters” in the “Vent System Care” section.

5.Install glass. See “Glass” in the “Vent System Care” section.

13