Jenn-Air W10526413C Make Electrical Connections for In-Line Blower Motor System, B A J

Make Electrical Connections for In-Line Blower Motor System

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

Electrical Connection Inside In-line Blower System

1.Disconnect power.

2.Connect the wires from the wiring conduit to the wires from the motor electrical plug cable inside the in-line blower housing terminal box.

7.Use UL listed wire connectors and connect the gray wires (G) together.

WARNING

Electrical Shock Hazard

Electrically ground blower.

Connect ground wire to green and yellow ground wire in terminal box.

Failure to do so can result in death or electrical shock.

8. Connect the green (or yellow/green) ground wire to the

green/yellow ground wire (H) in the terminal box using UL

listed wire connectors.

B

A

J

A. UL listed or CSA approved ¹⁄₂" (1.3 cm) wiring conduit

B. UL listed wire connectors C. Black wires

D. White wires E. Red wires

C

D

E

F

G

H

I

F. Blue wires G. Gray wires

H. Green (or yellow/green) and green/yellow wires

I. Motor electrical plug cable

J. UL listed or CSA approved ¹⁄₂" (1.3 cm) strain relief

9.	Reinstall the in-line blower terminal box cover and screw.
10.	Reinstall the front cover of the in-line blower housing and
	secure it with 10 mounting screws.

Electrical Connection Inside Downdraft Vent Between In- line Blower System and Downdraft Vent

NOTE: Discard the 6-wire connector assembly supplied with the in-line blower motor system.

1.With the downdraft vent mounted, locate the terminal block inside the downdraft vent junction box.

2.Using a small ¹⁄₈" flat-blade screwdriver, loosen the screw in the 5 open spots of the terminal block.

3.Connect the same color wire from the in-line blower wiring conduit to the same color wires on the terminal block in the downdraft vent junction box (black to black, white to white, etc.).

4.Tighten the terminal block screws.

A

3.Use UL listed wire connectors and connect the black wires

(C)together.

4.Use UL listed wire connectors and connect the white wires

(D)together.

5.Use UL listed wire connectors and connect the red wires (E) together.

6.Use UL listed wire connectors and connect the blue wires (F) together.

	B	J	I
	C
	D
	E		H
	F	G
A.Downdraft vent junction box	G. Terminal block
B. Black wires	H. Power supply cord
C. Gray wires	I. ½" (1.3 cm) UL listed or CSA
D. Red wires	approved wiring conduit
E. White wires	from in-line blower system
	J. ½" (1.3 cm) UL listed or CSA
F. Green (or yellow/green)
	approved conduit connector
and green/yellow wires

12