Remote Control Operation
A |
|
|
|
|
|
|
|
|
|
|
|
| B | ||||||||||
|
|
|
|
|
|
| |||||||||||||||||
F |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| C | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
|
| |||||||||||||
|
|
|
|
|
|
|
|
| |||||||||||||||
E |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| D | ||||
|
|
|
|
|
|
|
|
|
| ||||||||||||||
|
|
|
|
|
|
|
|
| |||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
A. Power on/off | D. Fan auto off | ||||||||||||||||||||||
B. Up/down | E. Fan speed decrease | ||||||||||||||||||||||
C. Maximum fan speed | E. Fan speed increase | ||||||||||||||||||||||
NOTE: The infrared remote (IR) sensor is located on the top right surface of the ventilation system top frame. When the remote communicates with the sensor, there is an audible signal.
Power On/Off
■When hood is in the down position, the On/Off button raises hood, turns on the lights and sets the fan speed to 1 (minimum). One speed indicator light comes on.
■When hood is in the raised position, the On/Off button turns the blower and speed indicator light off.
Up/Down
■The up/down button raises and lowers the hood. The lights and fan turn Off in the down position.
Fan Speed Increase
■Increases fan speed from speed 1 to speed 4. The number of fan speed indicator lights increases as the fan speed increases.
Fan Speed Decrease
■Decreases fan speed from speed 4 to speed 1. The number of fan speed indicator lights decreases as the fan speed decreases.
Maximum Fan Speed
■Turns the fan directly to speed 4 without stepping through speeds
Auto Off (fan only)
■Steps down (decreases the fan speed) through the speeds to Off (33 minutes to Off from maximum speed). The left indicator light blinks and the fan speed indicator lights turn Off as the fan speeds change.
■Steps down from speed 4 to speed 3 - (3 minutes).
■Steps down from speed 3 to speed 2 - (5 minutes).
■Steps down from speed 2 to speed 1 - (10 minutes).
■Steps down from speed 1 to OFF - (15 minutes).
NOTE: If the remote stops functioning properly, remove the batteries for 1 minute and then reinstall the batteries. (See “Changing the Remote Batteries” in the “Vent System Care” section.) This will reset the remote to its original settings.
If the remote still does not function properly, change the batteries. The remote requires 2 - CR2032 batteries.
15
