6.0SECOND STAGE PROCEDURES
6.1TOOLS REQUIRED FOR SECOND STAGE SERVING
-5/32" nut driver (if you don't have a 5/32" nut driver, use a 5/16 - 18 x 2" socket set screw)
-5/8" wrench
-3/4" wrench
-1/4" nut driver
-Slotted screwdriver
-Size "0" square drive screwdriver (such as a Channel Lock
-# 10 Tom screwdriver
-Phillips screwdriver
-Side cutting pliers
-Sherwood Lever Height Adjusting Tool (p/n
-Red Loctite® (stud locking adhesive)
6.2DISASSEMBLY Of SECOND STAGE
To view the complete parts list of the second stage, fold out the back cover of this manual.
1Remove the mouthpiece 14 by cutting the mouthpiece tie 15 with side cutting pliers. Examine the condition of the mouthpiece. Pay particular attention to the area on top just behind where the old tie tightened. This is a prime area for small holes to develop. If the mouthpiece is in good condition, it can be reused.
2.Remove the two cover retaining screws 20 using a size "0" square drive screwdriver or a Phillips screwdriver.
NOTE: Always remove these screws before peeling the cover off the case. If you peel the cover off the case without removing these screws, eventually the screw holes in the cover will elongate and no longer hold the screws. This is not covered under warranty!
3.Roll the cover 21 off the top of the case 17 using your thumb and forefinger.
4.At this point the Sherwood logo on the purge button 22 can be changed to a different color. See the parts list on the foldout back cover for available colors. If you are going to change the color, follow the next five steps. Otherwise, go on to Item 5 in this section.
a. Look at the tab inside the cover that holds the logo in place.
13