MENU - PEDAL
Pedal
Basics
•Press MENU to access
•Select Pedal using encoder D
•Press MENU to confirm
•Set values using encoders A, B and C
•Change pages using encoder D
•Confirm selection by pressing MENU if <menu> flashes in the right side of the display
•Exit by pressing MENU again
For external control of certain parameters you can connect an expression* pedal.
In this menu you assign which parameters to assign, calibrate
Parameters marked with “P”
Some of the parameters in this menu are global parameters and some are saved at preset level. Parameters saved with each preset are marked with “p” in the right side of the display.
Example:
PEDAL MENU <menu> Map Param.: DLY DELAY P
*Best result is achieved using a regular expression pedal with a linear potentiometer. However, you may also achieve satisfying results using a regular volume pedal.
Connecting Expression pedals
Depending on the type of expression pedal used, the pedal should be connected using either a regular mono 1/4"
Mono
Stereo
If you are not sure which type to use, you may have to try both types.
Map Parameter
Assigning parameters to the pedal connected to the “Pedal Input”
PEDAL MENU <menu> Map Param.: DLY DELAY P
•Select a parameter to control from the list
•Press MENU to confirm
•Set Min Mid Max
Min - Mid - Max
Range:
These settings determine the parameter response according to an expression pedal connected to the Pedal input. Values can be set for both the minimum, mid and maximum position of the pedal.
17