When the selected zone is set to EXT, the display shows the MIDI CC numbers.
The default parameters assigned for each knob are as follows.
A:#10 Panpot (PAN)
B:#70 Sustain Level (STN)
C:#76 Vibrato Rate (VbR)
D:#77 Vibrato Depth (VbD)
Note:
If the selected zone is set to BOTH, changing the MIDI CC# parameters affects both internal and external sections. If you want different settings for internal and external sections, enter the edit mode by pressing the MENU button and select internal or external section with the ZONE SELECT button. (See page33 for details.)
Changing MIDI CC parameter
Press and hold the MIDI CC# button. The MIDI CC# button starts blinking and the cursor in the display moves up to the parameter name.
Use the CONTROL KNOBS to change the parameters.
After changing the parameter, press the MIDI CC# button again. The MIDI CC# button stops blinking and the cursor in the display moves down to the value.
Note:
When the selected zone is set to INT, only the following parameters can be selected.
10 | Panpot | PAN |
70 | Sustain Level | STN |
71 | Resonance | RSN |
76 | Vibrato Rate | VbR |
77 | Vibrato Depth | VbD |
78 | Vibrato Delay | VbY |
93 | Chorus Depth | ChD |
When the selected zone is set to BOTH and the internal section is selected in edit mode, the parameters not available for INT section show as “ XXX”.
31