Kawai MP5 Transmitting Volume Ext only, Transmitting Control Change Ext only, 22 Pan, Fine Tune

6.2.19 Transmitting Volume (Ext only)

This parameter determines if an initial MIDI Volume message will be transmitted (On) to an external MIDI device or not (Off) when a SETUP is recalled.

Note:

In a zone set to External or Both, moving the faders will still transmit volume messages even if TX Volume is set to Off.

6.2.20 Volume

This parameter sets the volume level for the selected zone. The value can be changed by using the FADER or VALUE buttons.

For External zones, when the TX Volume is “Off”, this page won’t be displayed.

6.2.21 Transmitting Control Change (Ext only)

This parameter determines if the Pan/Fine Tune/Control Knob settings will be transmitted (On) via MIDI or not (Off) when a SETUP is recalled.

Note:

In a zone set to External or Both, moving the Control Knobs will still transmit the values even if TX CC is set to Off.

6.2.22 Pan

Int:	This sets the pan-pot (right and left balance).
Ext:	This sets the pan-pot value that will be transmitted to external sound modules.
	If the TX CC is “On”, the value is transmitted when a SETUP is recalled. When
	the TX CC is “Off”, this page won’t be displayed.

The value changes from L63 to R63.

6.2.23 Fine Tune

Int:	This is a fine tuning function for values smaller than a semi-tone.
Ext:	This is used to transmit fine tuning settings to external sound modules. If the
	TX CC is “On”, the value is transmitted when a SETUP is recalled. When the
	TX CC is “Off”, this page won’t be displayed.

The value changes from -63 to +63.

6.2.24 Damper

This parameter determines if the damper pedal is active (Norm [Int] / On [Ext], with natural decay), deactivated (Off) or set to HOLD (On, with steady sustain level) for the selected zone.

Use the HOLD value, if you don’t want a sound to disappear. HOLD is only available for internal Sounds.

38