Kawai CE200 manual Indicates a potential hazard that could result in injury

Page 4

Do not disassemble, repair or modify the product.

When disconnecting the AC power cord's plug, always hold the plug

and pull it to remove it.

The product is not completely disconnected from the power supply even when the power switch is turned off. If the product will not be used for a long time, unplug the AC power cord from the AC outlet.

Doing so may result in product breakdown, electric shock or short-circuit.

●Pulling the AC power cord itself may damage the cord, causing a fire, electric shock or short-circuit.

●Failure to do so may cause fire in case of lightning.

●Failure to do so may over-heat the product, resulting in fire.

This product may be equipped with a polarized line plug (one blade wider than the other). This is a safety feature.

If you are unable to insert the plug into the outlet, contact an electrician to replace your obsolete outlet.

Do not defeat the safety purpose of the plug.

It is a good practice to have the instrument near the AC outlet and the power cord plug in a position so that it can readily be disconnected in an emergency because electricity is always charging while the plug is in the AC outlet even in a power switch off condition.

Indicates a potential hazard that could result in injury

CAUTION or damage to the product or other

Do not use the product in the following areas.

●Areas, such as those near windows, where the product is exposed to direct sunlight

●Extremely hot areas, such as near a heater

●Extremely cold areas, such as outside

●Extremely humid areas

●Areas where a large amount of sand or dust is present

●Areas where the product is exposed to excessive vibrations

Using the product in such areas may result in product breakdown.

Use the product only in moderate climates (not in tropical climates).

When you close the keyboard cover, close it gently.

Before connecting cords, make sure that the power to this product

and other devices is turned OFF.

Take care not to allow any foreign matter to enter the product.

Do not drag the product on the floor. Take care not to drop the product.

Do not place the product near electrical appliances such as TVs and

radios.

When connecting the AC power cord and other cords, take care

not to get them tangled.

Closing it roughly may trap your fingers, resulting in injury.

OFF

Failure to do so may cause breakdown of this

 

product and other devices.

Entry of water, needles or hair pins may result in breakdown or short-circuit.

The product shall not be exposed to dripping or splashing. No objects filled with liquids, such as vases, shall be placed on the product.

Please lift up the product when moving it. Please note that the product is heavy and must be carried by more than two persons.

Dropping the product may result in breakdown.

● Doing so may cause the product to generate noise.

● If the product generates noise, move the product sufficiently away from the electrical appliance or connect it to another AC outlet.

Failure to do so may damage them, resulting in fire, electric shock or short-circuit.

4

KAWAI DIGITAL PIANO CE200

Page 3 Page 5
Image 4
Page 3 Page 5
Contents CE200 Page Important Safety Instructions Indicates a potential hazard that could result in injury Instruction for AC power cord U.K Declaration of Conformity Thank YOU for Purchasing a Kawai Digital Piano Read ME FirstParts Provided Side Panel a Pcs Back Board B Pedal Board CBottom View Pedal Unit Fasten the main unit and the stand with four screws DAttaching the Headphone Hook Piano Music Jacks Supplying AC Power Assembling the StandTurning on the power Adjust the volume levelPlaying the Piano PedalsPlaying with More Sounds Selecting Another Preset SoundPress the Sound Select button under the name About Polyphony Value ButtonsEntering Four Hands Mode Four Hands ModeSelecting Split Sounds Changing the Split PointExiting Four Hands Mode Selecting Sounds in Four Hands ModeChanging Split Point Octave Shift for the Lower SectionTo ADD Reverb To ADD Other EffectsVoicing NormalMellow DynamicStarting the Metronome Changing the Time SignatureRhythm Metronome MetronomeAdjusting the Metronome Volume Basics of the Recorder TWO-TRACK THREE-SONG RecorderRecorded Information Sound selection Pedal movementsRecording Another Song Recording REC ButtonRecording Capacity Recorder and MetronomePress the PLAY/STOP button when you are finished recording Recording a Second PartStatus of Song and Part Playing Back the Parts SeparatelyPlaying Back a Song PLAY/STOP Button Press the PLAY/STOP button again to stop play backUsingthe PLAY/STOP Buttonto Start Recording Erasing ALL the SongsErasing a Song Start flashingPiano Music Selecting the Touch Sensitivity Touch Button User Touch Transposing the Piano Transpose ButtonTuning Multi Timbral ModeUser Memory / Factory Reset BrillianceTuning BrillianceDamper Resonance Use the Value buttons to raise or lower the pitchPress the Piano button while holding down the Touch String ResonanceAbout String Resonance Brief Explanation of Temperaments TemperamentEqual Temperament Piano only Pythagorean Temperament Meantone TemperamentWerckmeister III Temperament Kirnberger III Temperament Equal Temperament FlatKEY Signature of Temperament Lower Octave ShiftMidi Channel Sending Program Change NumbersLocal Control ON/OFF Use the Value buttons to change the channel numberMULTI-TIMBRAL Mode ON/OFF Transmit Program Change ON/OFFMulti-Timbral On On1 and On2 Multi-Timbral OffChannel Mute Lower Pedal ON/OFFThen use the Value buttons to turn them on and off Can not be selectedLayer Dynamics Layer Octave ShiftLayer Octave Shift can be set between -2 to User Memory / Factory Reset Following settings can be savedFactory Reset Damper HoldFunction Buttons What is MIDI? Understanding MidiMidi Jacks Midi ChannelBass Using the CE200 Piano AS Controller Midi ConnectionChanging Transmitting Channel Electric Piano button while holding down the TouchNow You’re ready to play Audio ConnectionProgram Change Local Control ButtonsUsing the CE200 Piano AS a MULTI-TIMBRAL Sound Module MULTI-TIMBRAL Mode Using Midi Windows XP / Me users About a USB DriverWindows 2000 / 98SE users Macintosh OS X users Users of Macintosh OS9 or earlierLine OUT Jacks Bottom ViewJacks Program Change Number Mapping Rhythm Style ListPiano Music List Front Panel Sound Demo Song ListSpecifications Midi Exclusive Data Format Midi Implementation Chart Kawai Digital Piano Model CE200Eng
Top Page Image Contents