Kawai CE200 manual Declaration of Conformity

Page 6

FCC Information (U.S.A)

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

FCC WARNING: Changes or modifications not expressly approved by the party responsible for compliance could void the userís authority to operate the equipment.

Declaration of Conformity

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and

(2)this device must accept any interference received, including interference that may cause undesired operation.

Model Name :	CE200
Responsible Party Name :	Kawai America Corporation
Address :	2055 East University Drive Rancho
	Dominguez, CA 90220
Telephone :	310-631-1771

This applies only to products distributed by Kawai America Corporation.

6	KAWAI DIGITAL PIANO CE200

Image 6

Contents CE200 Page Important Safety Instructions Indicates a potential hazard that could result in injury Instruction for AC power cord U.K Declaration of Conformity Parts Provided Thank YOU for Purchasing a Kawai Digital PianoRead ME First Side Panel a Pcs Back Board B Pedal Board CBottom View Pedal Unit Fasten the main unit and the stand with four screws DAttaching the Headphone Hook Piano Music Jacks Supplying AC Power Assembling the StandPlaying the Piano Turning on the powerAdjust the volume level PedalsSelecting Another Preset Sound Playing with More SoundsPress the Sound Select button under the name About Polyphony Value ButtonsSelecting Split Sounds Entering Four Hands ModeFour Hands Mode Changing the Split PointChanging Split Point Exiting Four Hands ModeSelecting Sounds in Four Hands Mode Octave Shift for the Lower SectionTo ADD Reverb To ADD Other EffectsMellow VoicingNormal DynamicRhythm Metronome Starting the MetronomeChanging the Time Signature MetronomeAdjusting the Metronome Volume Recorded Information Basics of the RecorderTWO-TRACK THREE-SONG Recorder Sound selection Pedal movementsRecording Capacity Recording Another SongRecording REC Button Recorder and MetronomePress the PLAY/STOP button when you are finished recording Recording a Second PartPlaying Back a Song PLAY/STOP Button Status of Song and PartPlaying Back the Parts Separately Press the PLAY/STOP button again to stop play backErasing a Song Usingthe PLAY/STOP Buttonto Start RecordingErasing ALL the Songs Start flashingPiano Music Selecting the Touch Sensitivity Touch Button User Touch Transposing the Piano Transpose ButtonUser Memory / Factory Reset TuningMulti Timbral Mode BrillianceDamper Resonance TuningBrilliance Use the Value buttons to raise or lower the pitchString Resonance Press the Piano button while holding down the TouchAbout String Resonance Temperament Brief Explanation of TemperamentsEqual Temperament Piano only Werckmeister III Temperament Kirnberger III Temperament Pythagorean TemperamentMeantone Temperament Equal Temperament FlatKEY Signature of Temperament Lower Octave ShiftLocal Control ON/OFF Midi ChannelSending Program Change Numbers Use the Value buttons to change the channel numberMulti-Timbral On On1 and On2 MULTI-TIMBRAL Mode ON/OFFTransmit Program Change ON/OFF Multi-Timbral OffThen use the Value buttons to turn them on and off Channel MuteLower Pedal ON/OFF Can not be selectedLayer Octave Shift Layer DynamicsLayer Octave Shift can be set between -2 to Factory Reset User Memory / Factory ResetFollowing settings can be saved Damper HoldFunction Buttons Midi Jacks What is MIDI?Understanding Midi Midi ChannelBass Changing Transmitting Channel Using the CE200 Piano AS ControllerMidi Connection Electric Piano button while holding down the TouchAudio Connection Now You’re ready to playProgram Change Local Control ButtonsUsing the CE200 Piano AS a MULTI-TIMBRAL Sound Module MULTI-TIMBRAL Mode Using Midi About a USB Driver Windows XP / Me usersWindows 2000 / 98SE users Macintosh OS X users Users of Macintosh OS9 or earlierLine OUT Jacks Bottom ViewJacks Program Change Number Mapping Rhythm Style ListPiano Music List Front Panel Sound Demo Song ListSpecifications Midi Exclusive Data Format Midi Implementation Chart Kawai Digital Piano Model CE200Eng