Casio CTK-571 manual Messages, Touch Curve Default, Sound Range Shift Default On

Page 41

TOUCH CURVE (Default: 0)

0:Normal touch curve

1:Louder than normal tone, even when little pressure is used to press keyboard keys. When touch response is turned off, sound is pro- duced at a louder volume than normal.

1. Press the TRANSPOSE/TUNE/MIDI button until the TOUCH CURVE SELECT screen appears.

2. Use the [+] and [–]or [0] and [1] buttons to change the setting.

Example: To select touch curve 1

ASSIGNABLE JACK

SUS(sustain): Specifies a sustain*1 effect when the pedal is de- pressed.

SoS (sostenuto): Specifies a sostenuto*2 effect when the pedal is de- pressed.

SFt (soft): Specifies reduction of the sound’s volume when the ped- al is depressed.

rHy (rhythm): Specifies START/STOP button operation when the pedal is depressed.

1. Press the TRANSPOSE/TUNE/MIDI button until the ASSIGNABLE JACK screen appears.

Example: When sustain is currently set

2. Use the [+] and [–] or [0], [1], [2], and [3] buttons to change the setting.

Example: To select rhythm

*1 Sustain

With piano tones and other sounds that decay, the pedal acts as a damper pedal, with sounds being sustained longer when the pedal is depressed. With organ tones and other continuous sounds, notes played on the keyboard continue to sound until the pedal is released. In either case, the sustain effect is also applied to any notes that are played while the pedal is depressed.

*2 Sostenuto

This effect performs the same way as sustain, except that it is applied only to notes that are sounding already when the pedal is depressed. It does not affect notes that are played after the pedal is depressed.

★When SUS is set

Pedal depressed

Pedal released

★When SoS is set

Pedal depressed

Pedal released

= Keyboard depressed. = Sustained notes

SOUND RANGE SHIFT (Default: On)

on: Shifts low range tones one octave lower and 072 PICCOLO one octave higher.

oFF:Plays low range tones and 072 PICCOLO at their normal levels.

1. Press the TRANSPOSE/TUNE/MIDI button until the SOUND RANGE SHIFT screen appears.

2. Use the [+] and [–]or [0] and [1] buttons to change the setting.

Example: To turn SOUND RANGE SHIFT off

Messages

There is a wide variety of messages defined under the MIDI stan- dard, and this section details the particular messages that can be sent and received by this keyboard. An asterisk is used to mark messages that affect the entire keyboard. Messages without an asterisk are those that affect only a particular channel.

NOTE ON/OFF

This message sends data when a key is pressed (NOTE ON) or re- leased (NOTE OFF).

A NOTE ON/OFF message include a note number (to indicate note whose key is being pressed or released) and velocity (keyboard pres- sure as a value from 1 to 127). NOTE ON velocity is always used to determine the relative volume of the note. This keyboard does not receive NOTE OFF velocity data.

Whenever you press or release a key on this keyboard, the correspond- ing NOTE ON or NOTE OFF message is sent from the MIDI OUT terminal.

Press the key

 

MIDI OUT Terminal

NOTE ON

• Note number (tone)

• Velocity (volume)

Release the key

 

MIDI OUT Terminal

NOTE OFF

• Note number (tone)

• Velocity (volume)

702A-E-041A

E-39

Page 40 Page 42
Image 41
Page 40 Page 42
Contents USER’S Guide Guía DEL Usuario FCC Warning Welcome Main Features Symbols Safety PrecautionsDo not disassemble or modify the instrument Care Care of your keyboardContents Midi Attaching the Score Stand General GuideRear Panel Playing a Demo TuneSet the Mode switch to Normal Press the Power button to turn on powerQuick Reference To play the keyboardAccessories and Options Connecting to a Computer or Other EquipmentConnections Phones/Output TerminalUsing batteries Power SupplyUsing the AC Adaptor Important Battery InformationSettings and Memory Contents Auto Power OffSelecting a Tone Basic OperationsTo play the keyboard Use the Tempo buttons to set the tempo Using the MetronomeTo start the metronome Auto Accompaniment Adjusting the TempoSelecting a Rhythm Playing a RhythmTo use Auto Accompaniment Using Auto AccompanimentCasio Chord Accompaniment Keyboard and Melody Keyboard Chord TypesC7sus4 Cadd9 Cmadd9 CmM7 Cdim7 Csus4 Cm7 Cmaj7Fingered Accompaniment Keyboard and Melody Key- board Full Range Chord Accompaniment Keyboard and Melody KeyboardUsing a Fill-in Pattern Using an Intro PatternUsing a Rhythm Variation Using a Fill-in Pattern with a Variation RhythmFinishing with an Ending Pattern Adjusting the Accompaniment VolumeUsing One-touch Preset To play back a Song Bank tune Playing a Built-in TuneUse the number buttons to input the tune’s two-digit number Press the PLAY/PAUSE button to start play of the tuneMusical Information System To play an Etude tuneTo play a Concert Piece tune To fast reverse To pause playbackTo fast forward To change the melody toneStep Lesson Tempo Setting Display Contents During 3-step Lesson PlayStep Lesson Tune Types and Their PartsPress any keyboard keys to play the melody right hand part Master the timingMaster the melody Accompaniment left hand part starts to play at normal speed Play a normal speedTracks Memory FunctionMemory Button Operation Selecting a TrackTrack 1 Contents After Real-time Recording To record to Track 1 using real-time recordingReal-time Recording to Track Memory CapacityMemory Data Storage Playing Back from MemoryTrack 1 Real-time Recording Variations To play back from memoryTo record to Track 2 without playing back Track Track 2 Contents After Real-time RecordingTo record to Track 2 while playing back Track Deleting the Contents of a Specific Track Using Layer Keyboard SettingsUsing Split To layer tonesTo split the keyboard and then layer tones Using Layer and Split TogetherNow try playing something on the keyboard Input the number of the layered split toneTransposing the Keyboard Using Touch ResponseTo turn touch response on and off To transpose the keyboardTo tune the keyboard Tuning the KeyboardMidi Channels What is MIDI?Midi Connections GM Mode Default Off Changing Midi SettingsNavigate Channel Default General MidiLocal Control Default On Midi in Chord Judge Default OffAccomp Midi OUT Default Off Local Control On Local Control OffSound Range Shift Default On Touch Curve DefaultUse the + and -or 0 and 1 buttons to change the setting MessagesGM System OFF F07E7F0902F7 Effect Control NumberGM System on F07E7F0901F7 Problem Possible Cause Action See TroubleshootingSpecifications Tabla de notas Appendix/ApéndiceRange Type Sonidos de DeLista Fingered Chord Chart Cuadros de acordes Fingered Aug Sus4 7sus4 Add9 MM7 Tone List Lista de sonidos Rhythm List Lista de ritmos Mode3 Remarks Recognized TransmittedTruevoice NumberSystem RealTime True#Aux RemarksHon-machi 1-chome
Top Page Image Contents