American Dynamics ADCC1100 manual Storing the Macro Page Configuration to the Smart Card

ADCC1100

After entering the first character, press the NEXT soft key. This will move the text editor's cursor (underscore "_") to the next character of the title. Enter the next character, and so on. If a character is entered erroneously, use the CLEAR key to move the cursor backwards then, re-enter the character.

When the title is complete, press the ENTER soft key. The text editor menu will close and the display will return to the configure macro menu (figure 4.2).

Storing the Macro Page Configuration to the Smart Card

To store the macro page configuration to the smart card:

1.From the configure macro page (figure 4.2), press the STORE CONFIG soft key. The macro page and macro icon definitions will be written to the current smart card.

Programming a Macro Icon

To set the icon used to identify a macro:

1.Press the PROGRAM MODE tab key.

2.Press the NEXT soft key.

3.Press the MACRO CONFIG soft key. The configure macro menu will be displayed (figure 4.2).

4.Select the macro page on which the icon is located (1 - 8) using the NEXT PAGE / PREV PAGE soft keys.

5.The eight macro icons are referenced by the configure macro menu by the numbers 1 to 8—see figure 4.4. Enter the number corresponding to the icon to be programmed (1 - 8) and press the KEY ID soft key.

1

2

3

4

Macro	Monitor		Camera	Macro
One				Five
Macro				Macro
Two				Six
Macro	Page One			Macro
Three				Seven
Macro	Enter			Macro
Four				Eight
Operator		Previous		Next

5

6

7

8

Figure 4.4: Macro Icon Reference Numbers

6.Enter the reference number for the desired icon (see appendix C) and press the ICON REF soft key.

30