Quicksite Configuration

American Dynamics ADCC1100 manual Configuring for MP48, AD1024 or Quicksite Mode

ADCC1100

Configuring for MP48, AD1024 or Quicksite Mode

The ADCC1100 keyboard is designed for use with the MP48 or AD1024 matrix switch- ing system. The ADCC1100 keyboard needs to be set to one of these systems in order to operate correctly.

Quicksite mode should be used to support systems with multiple AD1024 matrix sites where switching between satellite sites has been configured to take place automati- cally. For example, a system with three distinct satellite sites can be created, each with its own video inputs, video outputs and keyboards. Once trunk connections have been made between the satellite sites, a keyboard from one site can be used to call video inputs from another site, without having to select the site first. All the operator needs to do is enter the pseudo number of the required video input. Refer to the AD1024 Satellite Configuration Installation Instructions for details on how AD1024 matrices can be configured for this functionality.

AD1024 mode should be used to support single AD1024 switching matrices or systems with multiple AD1024 sites where satellite site selection is to carried out manually. This mode also supports the AD2150 switching matrix. MP48 mode should be used to support the MP48, MP48+, AD168, MP168 and AD MP-LT matrix systems.

1.Using the Administrator's smart card, log on to the system.

2.Press the PROGRAM MODE tab key.

3.Press the NEXT soft key.

4.Press the MP48 MODE/AD1024 MODE/QUICKSITE MODE soft key. This has a toggle action selecting MP48 Mode, AD1024 Mode or Quicksite Mode.

5.Remove the Administrator's smart card.

The keyboard is now set to the selected mode and will retain this setting—even after powering off the keyboard—until it is changed again using the steps above.

Note: See the section Quicksite Configuration below for details on specifying camera pseudo numbers in the Quicksite configuration menu.

When Quicksite mode has been selected as the mode of operation for the matrix (see above), an operator with administrator privileges can use an ADCC100 keyboard to configure Quicksite settings.

To open the Quicksite configuration menu:

1.Press the PROGRAM MODE tab key.

2.Press the NEXT soft key.

3.Ensure that the MP48 MODE/AD1024 MODE/QUICKSITE MODE soft key is set to Quicksite mode.

4.Press the PARTITION QUICKSITE soft key. The partition menu will be displayed (figure 4.6), but an extra soft key is added to the bottom right of the screen.