2.Press the 1/PREV or 2/NEXT button (3.3) to make the name display (3.8) show “PCHG OUT.”
3.Specify whether program change messages will be transmitted. Use value knob 3 (2.5) or the ▲, ▼ buttons (3.2) to make the desired setting.
“OFF”: Program change messages will not be transmitted.
“On”: Program change messages will be transmitted.
CONTROL CHANGE (GLOBAL “CCHG I/O”)
When you operate the EXPRESSION pedal, VOLUME pedal, or TAP switch of an optional foot controller connected to ToneLab, control change messages will be transmitted. This means that functions for the corresponding control change num- bers on an external MIDI device can be controlled in realtime.
Similarly, when ToneLab receives control change messages from an external MIDI device, it will be controlled in the same way as if its own foot controller were oper- ated.
For a list of the functions that can be controlled from an external MIDI device, refer to step 4.
Here you can specify whether ToneLab will transmit and receive control change messages.
1.Press the GLOBAL button (3.5) to make the button light.
2.Press the 1/PREV or 2/NEXT button (3.3) to make the name display (3.8) read “CCHG I/O.”
3.Specify whether all control change messages will be transmitted or received. Use value knob 3 (2.5) or the ▲, ▼ buttons (3.2) to make your choice.
“On” allows transmitting and receiving. “OFF” disables transmitting and receiv- ing.
NOTE: If this setting is “OFF,” no control change messages will be transmitted or received even if you specify individual control change numbers in step 4.
4.Use the 3/√ or 4/® buttons to select the controller for which you want to trans- mit or receive settings. The controllers will be selected in the following order.
“EXP PDL”: EXPRESSION pedal control
“VOL PDL”: VOLUME pedal control
“TAP SW”: TAP switch on/off
“PEDAL FX”: PEDAL effect on/off
“MOD FX”: MODULATION effect on/off
“DELAY FX”: DELAY effect on/off
“REVRB FX”: REVERB effect on/off
5.For each controller, specify whether ToneLab will transmit and receive control change messages. If you want ToneLab to transmit and receive messages for a controller, specify the control change number. Select a controller, and use value knob 3 (2.5) or the ▲, ▼ buttons (3.2) to make the desired setting.
“OFF”: Control change messages will not be transmitted or received.
| Tuner |
|
| Foot | Controller |
|
|
|
|
|
|
| MIDI/DIGITAL |
|
|
|
|
| Factory | settings |
| Trouble- | shooting |
| Spec. |
|
| Program | List |
|
|
|
47