Triamp MK II and Midi | Hughes & Kettner instruction

TRIAMP MK II - MANUAL

4.4 TRIAMP® MK II AND MIDI

With the MSM-1 MIDI Module installed, you can use your multieffects processor to sel- ect TriAmp® MK II channels and turn the FX LOOP on or off via MIDI.

Installing the MSM-1 MIDI Module

MIDI IN	MIDI	MIDI THRU
	RECEIVE
	CHANNEL
	CHANNEL

ON OFF

1 2 3 4 OMNI

CHANNELS 5-16: SEE MANUAL

NOTE (VERY IMPORTANT):

The following instructions are intended solely for a factory authorized technician.

•Unplug the amp's mains cord from the wall socket and remove all connected cables (e.g. to the spring reverb or speakers).

•Remove the amp's rear panel cover so you can access the tubes.

•Prepare a suitable spot to set the amp chassis (for instance two books placed the same distance apart as the two transformers),

or remove the power amp tubes.

•Remove the four retaining screws that hold the chassis in place, and carefully pull the amp chassis out of the wood housing.

•Remove the MIDI Module port cover plate from the rear panel of the chassis.

•Insert the included flat cable connector plug in the MSM-1's socket so that the color-coded wire faces the notch on the socket.

MSM-1 socket and indicator notch.

•Insert the MSM-1 into the module port, and affix it in place using the same four screws you just removed a moment ago. Make sure the writing on the MSM-1 reads in the same direction as that on the rest of the chassis back.

Location of the sockets.

	MSM-1
FX	OUTPUT

•On the control circuit board you will find the socket for the connector on the other end of the ribbon cable. Also insert this connector in the socket so that the color-coded wire faces the notch on the socket.

•Double-check that the module and the connectors are seated correctly.

•Replace the chassis in the housing and, if you removed the tubes, the tubes in the chassis.

•Replace the amp's rear panel, and reconnect the cables to the reverb and speakers.

•To use the MIDI LEARN function with the TriAmp® MK II, please refer to the instructions included with the MSM-1 MIDI Module.

The moment power is applied to the amp, the MIDI functions of the TriAmp® MK II are immediately available. Please check all switching functions of the amp.

ENGLISH